dbx AFS 224 Manual del usuario - Página 10

Navegue en línea o descargue pdf Manual del usuario para Hardware informático dbx AFS 224. dbx AFS 224 20 páginas. Dual channel advanced feedback suppression processor
También para dbx AFS 224: Manual (20 páginas)

Imprimir página
dbx AFS 224 Manual del usuario
Operation

User Setup

3
AFS 224 User Manual
User Setup
+3
+2
+1
-0
-1
-2
d
-3
B
u
-4
-5
-6
-7
-8
-9
700
750
Live Filter Lift: Live Filter Lift provides maximum sonic integrity by removing unnecessary
feedback filters. This button is used to select the live filter lift times and are indicated as follows:
Mode: This button is used to select FIXED (button is green) or LIVE (button is red). The Mode
button is also used to set the number of filters. For more information please see Section B Set
Up
AFS Filter LEDs: The AFS 224 offers 24 filter LEDs per channel, which are used to indicate the
number of fixed and set filters within each channel.
This section of the manual is provided to give the user step-by-step instructions for setting up
and optimizing the performance of the AFS 224.
A - Setting Gain Structure
The four basic ways to hookup the AFS 224 to your system are as follows:
1) Connected to the insert jack(s) on a microphone channel of a mixer.
2) Connected to the insert jack(s) on the main outputs of a mixer.
3) Connected to the subgroup insert jack(s) of a mixer.
4) Connected inline w/outputs of a mixer (output of mixer to input of 224, output of 224 to amplifiers).
For maximum performance and proper operation, the average input signal should consistently
light the 0 dBu LED, with the +10 dBu LED occasionally lighting. Hookup methods 1, 2 & 3
above are the preferred way to connect the AFS 224 since the insert points on most mixers are
pre output fader. This allows the proper signal level to be fed to the AFS 224 without the chan-
nel or output fader affecting the level as the fader is moved up or down. Be sure to check the
mixer's manual for the nominal operating point for the insert jacks, and then select the +4dBu
or -10dBV switch on the back of the AFS 224 accordingly.
AFS 224 Filter Q's
Music High - 1/80th Octave
820 850
900
.95k
1k
Hz
LED
Lift Time
Not Lit -
Lift Off
Green -
10 Seconds
Yellow -
10 Minutes
Red -
60 Minutes
AFS 224
+3
+2
+1
-0
-1
Music Med - 1/20th Octave
-2
d
-3
B
u
Music Low - 1/10th Octave
-4
-5
Speech - 1/5th Octave
-6
-7
-8
-9
1.2k
®