Activocal AmpliTalk 100 Manual del usuario - Página 6

Navegue en línea o descargue pdf Manual del usuario para Teléfono Activocal AmpliTalk 100. Activocal AmpliTalk 100 18 páginas. Voice activated amplified telephone

Imprimir página

B. Fit the wall bracket (supplied with the phone) under the base of the phone,

placing the tabs on the bracket into the slots in the phone.

C. Select an area of the wall where you would like to hang your phone and

verify that there are no pipes or electrical wires buried in this area of the

wall.

D. Drill 2 holes and fix 2 screws at 10 cm intervals, leaving the heads of the

screw protruding.

E. Align the keyhole slots in the rear of the phone with the heads of the screws

and slide down slightly so that the heads of screws locate in the slots. If

necessary, adjust the screws so that the phone hangs flat and holds firmly on

the wall.

Ringer Settings

On the right side of the telephone, 2 switches allow a selection of 3 ringer settings,

"High" "Low" or "Off", and a choice of 2 different melodies.

Note: The AmpliTalk will also visually indicate all incoming calls with flashing led

lights located on the front and right side of the telephone, even when the ringer is

on the "Off" mode.

Adjusting the Volume and Tone of Incoming Calls

290 Andrews Rd. Feasterville - Trevose, PA 19053 USA

(888) 246 5984