DC 1100.1 Manual del usuario - Página 5

Navegue en línea o descargue pdf Manual del usuario para Amplificador DC 1100.1. DC 1100.1 8 páginas.

REM ( REMOTE )

Run a remote turn on cable from the switched + 12V source . This may be a toggle switch, a relay,

your source unit's remote trigger cables, or power antenna trigger cable. Connect the remote turn on cable

to the REM ( remote ) terminal.

+12V ( POWER CONNECTION )

Before mounting ampli ers, disconnect the negative ( ) cable from the ba ery to protect any accidential damage

to your awesome ampli ers and audio system.

Ampli ers are designed to use 4 ( 0 ) gauge power and ground connection.

Connect the power cables to power terminal + 12V.

All ampli ers do not have built-in fuses so they need external fuse connection.

Connect one end of fuse holder to the power cable going into the ampli ers and the other end of fuse holder

to positive ba ery.

This fuse location will protect the system and the vehicle against the possibility of a short circuit in the power cable.

Be sure to use fuses and fuse holder adequate for the application.

SPEAKER OUTPUT

This terminal connects the ampli ers to the speaker systems. Minimum speaker cable should be larger than

12 gauge.

Connect carefully the subwoofer or the speakers by checking the impedance 1ohm for 1100.1 & 2100.1

2ohm stereo or 4ohm bridged for 300.4 & 1000.4

4-4. Monoblock speaker connection.

4 ~ 1 ohms

Caution !!

1100.1 & 2100.1

Minimum working impedance is 1ohm.

Impedance lower than 1ohm can damage the ampli er