dynarex 12005 Manual del usuario - Página 5

Navegue en línea o descargue pdf Manual del usuario para Equipamiento médico dynarex 12005. dynarex 12005 9 páginas. Ltc 5 function ultra low bed

ASSEMBLY INSTRUCTIONS
2.6 CONNECTING CABLES TO THE
CONTROL BOX
Motor cables will need to be connected to the control
box, located at the center of the bed. The motors for
the backrest control and head section height adjust-
ment should already be connected.
1. Open the control box locking lid by pressing in the
sides and lift it up, to expose the connection ports.
2. The cables and the port connections are color-
coded. Route the cables to their matching port.
When running the cables, ensure they are neatly
tied along the bed frame and do not interfere with
the bed operation.
1. Backup Battery (if applicable)
2. Backrest Motor 1
3. Backrest Motor 2
4. Headboard Motor
5. Footboard Motor
6. Knee-break Motor
7. Underbed Lighting (if applicable)
8. Nursing Control (if applicable)
9. Hand pendant
1
2
3
4
5
6
7
3. Connect all cables and reinstate the locking lid,
ensure there is an audible click.
8
(Continued)
2.7 INSTALLING BATTERY BACKUP
1. Switch the power supply off when installing the
backup battery.
2. Affix the backup battery with nuts and bolts to the
left of the control box, on the same holding plate.
3. Open the control box locking lid by pressing in
the sides and lift it up, to expose the connections
ports.
4. Connect the backup battery cord to the control
box. The connection port is indicated with a bat-
tery symbol above.
5. Close the locking lid. There should be an audible
click. Switch the power supply back on.
8
9
Long-Term Care Bed • D500 • 5 Function Ultra Low Bed (Reorder No. 12005)
ASSEMBLY INSTRUCTIONS
2.8 INSTALLING THE RAILS OR
ASSIST BARS
1. Before installing the rails or bars, the bed should
be in the flat position.
2. Unclip the metal snap ring and remove the metal
pins from the rail mounting brackets.
3. Remove cover for the appropriate holes.
Holes for
Holes for
Holes for Assist Bars
Swing Rails
Swing Rails
4. Place the rail bracket onto the edge of the bed
decking. Align the rail bracket mounting holes
with the bed deck mounting holes.
Long-Term Care Bed • D500 • 5 Function Ultra Low Bed (Reorder No. 12005)
(Continued)
5. Re-insert the metal pins from the outside edge of
the bed through the mounting holes and secure
with the snap rings on the inside edge of the bed.
Make sure the snap rings are positioned in the
groove of the metal pins.
6. If the bed rail or bar has additional allen screws,
tighten the allen screws next to the metal pins.
7. Repeat the same procedure to install the other rail.
9