Autonics SCM-US48I Manual - Página 11

Navegue en línea o descargue pdf Manual para Media Converter Autonics SCM-US48I. Autonics SCM-US48I 13 páginas. Communication converter
También para Autonics SCM-US48I: Manual rápido (11 páginas), Manual del producto (2 páginas), Manual (11 páginas)

Imprimir página
Autonics SCM-US48I Manual
SCM Series
Serial Port Driver Installation
1) After installing USB Driver, Serial Port (COM port),
'Found New Hardware Wizard' will appear (Serial
Port Driver installation follows the same procedures
described in installing USB Driver).
2) After selecting 'Install from a list or specific location
(advance)', click 'Next' button. The following window will
be displayed for 'Search and installation options'
3) Because a driver location was selected when installing
USB driver, click 'Next' button.
4)Hardware installation message will appear while Found
New Hardware Wizard is running. Click 'Continue
Anyway' to proceed with installation.
5)'Completing the Found New Hardware wizard' will be
displayed if the Serial Port Driver is installed properly.
Click the 'Finish' button.
S-38
※ Verify that drivers were installed properly with the
windows Device Manager after finishing USB Driver and
Serial Port Driver installation.
Open the folder [My computer], open the system folder
(click right), click the hardware tab, and click the Device
Manager Button. Then, make sure that 'SCM-US48I
Driver (Autonics Corp)' or 'SCM-US Driver (Autonics
Corp)' is found in 'Common Serial Bus Controller'
category and 'Port (COM and LPT) is found in 'SCM-
US48I Serial Port (COM ) or 'SCM-US Serial Port (COM
)'.
※ This Driver Installation is described based on the
procedure for Windows XP.
There might be some differences in the specification
above depending on OS.