DC Power Solutions B-COOL12000WMB 24V Manual de inicio rápido - Página 12
Navegue en línea o descargue pdf Manual de inicio rápido para Accesorios para automóviles DC Power Solutions B-COOL12000WMB 24V. DC Power Solutions B-COOL12000WMB 24V 14 páginas. Split unit
Imprimir páginaIf any of the following situations occur during the use of air
conditioners, please find out a solution by following the index
Condition
If the cooling
effect is not good
There is water on
the surface of
indoor unit
The indoor unit
displays voltage.
fault
The indoor unit
displays sensor
fault
The indoor unit
displays fan fault
Installation and User Manual for vehicle Electric Air – Conditioners
The indoor unit
displays outdoor unit
fault
12
Troubleshooting - Air conditioners
If it's a fault, please contact the tech. / repair center.
Solution
Select the right mode and set proper temperature and speed.
Check if there is any obstruction at the air inlet and outlet
Check if the surface of the condenser is too dirty
Check if it is short of refrigerant and if the high and low
voltage is within the normal range
When running in an environment with high humidity, water
drops may form on at the air outlet and core surface, which
is a normal physical phenomenon
Check battery for low voltage and verify the power source is
either DC 12V or 24V
Check if the low voltage protection value is too high
Check if the sensor at air inlet / outlet is plugged in correctly
Check if the display temperature is higher than normal
ambient temperature. If it is, change the sensor.
Check if the fan is correctly plugged in. Connect the fan with
a separate 12V or 24V DC power source. If the fan doesn't
work, replace fan.
Check if it is short of refrigerant.
Check if the high and low voltage is within the normal range.
Check if the condenser is too dirty - so that heat dissipation
is adversely affected.