dynarex 10404 Manual - Página 2

Navegue en línea o descargue pdf Manual para Productos de cuidado personal dynarex 10404. dynarex 10404 16 páginas. Full electric bed with emergency hand crank

Imprimir página

GENERAL WARNINGS

Notices in this manual apply to hazards or unsafe practices which could result in personal injury and/or

property damage.

To ensure user safety in operating this Home Care Bed, all warnings, safety information and

instructions must be followed. Failure to do so may result in serious bodily injury or damage to the bed.

Once assembled for operational use, if any part of the bed is not working properly, call a qualified

technician to examine and repair it.

Routine cleaning and electrical inspection should be performed by the user.

All repair and maintenance on the bed should be performed by a qualified technician. After any

adjustments, repair or service and BEFORE use, make sure all attaching hardware is tightened securely.

Note to Technicians: Do not service the bed without first reading and understanding this.

If you are unable to understand the warnings, cautions or the instructions, contact an

authorized customer service sales rep or dealer before using this equipment, otherwise injury

or property damage may result.

We recommend that two (2) people perform the installation.

Inspect all parts for shipping damage before assembly and use. In case of damage to any part of the

bed's components, do not use that part. Contact the shipping carrier immediately for instructions on

reporting concealed shipping damage.

Assembly - Ensure that the head and foot deck sections are securely locked to each other and the head

and foot boards are secured to the deck BEFORE use.

After assembly, test to make sure that all of the bed sections are properly and securely installed and

operate correctly BEFORE use.

Keep all body parts including fingers and arms away when mechanism is moving. There are many

pinch points which could cause personal injury and/or damage to the bed.

Do not expose the bed to excessive heat or moisture

Make sure the bed is plugged into a properly grounded 110 volt outlet.

This bed is intended for home use only. It is NOT for nursing home facilities or hospital use and was not

designed to meet nursing home facility or hospital standards.

Ensure that the pendant and power cords are routed and secured properly so that the cords do not

become entangled, pinched and/or severed during operation of the electric bed or inhibit maneuvering

around the bed. NEVER operate the bed if these cords are damaged.

Ensure all cables and cords are routed in a way that they will not become entangled, pinched, or

run-over.

Be sure to check that all cords are not pinched, stretched or in any way stressed. Never wind cords

around the bed or other objects to compensate for excess cord length. Never allow cords to fall under

the casters.

Keep all moving parts and all drive shafts free of obstructions during operation of the bed. (i.e.

blankets/sheets, heating blankets/pads, tubing, wiring, etc. and other types of products using electric

cords which may get tangled around the bed, legs or optional side rails).

Never operate the bed if it has a damaged cord or plug. If the bed is not working properly call a

qualified technician.

Unplug the power cord from wall BEFORE performing any maintenance on the bed.

DO NOT force connectors into the junction, otherwise injury or damage may occur.