Galaxy Print Finishing VR-930 Manual de instrucciones - Página 10

Navegue en línea o descargue pdf Manual de instrucciones para Libreros Galaxy Print Finishing VR-930. Galaxy Print Finishing VR-930 15 páginas.

Troubleshooting:

If the machine is switched on but won't work at all:

The power cord is not

plugged in properly

The cover is open

No-Staple light is ON

Papers are not in

Paper-in tray

Staples jam

Paper jam

Black (Dark coloured)

covers

If the machine doesn't staple although the staple magazines are fully

filled with staples:

Staple Pusher is not

hinged on the pin

Staple Pusher is

missing or incorrectly

positioned

Push power cord thoroughly into the power outlet

Close cover

Re-fill Staples. Follow instrictions on page 4.

Place paper in Paper-In Tray and align to the Left &

Right Side Guides

1. Remove jammed staples. Follow instructions on

Page 3.

2. Always use our 26/6 or 26/8 standard staples.

3. Check if the Staples Pusher is scratched or worn

out. Follow the instructions on page 3 to put in a new

Staple Pusher.

1. To remove jammed sheets, press the "REVERSE"

button on the control panel to drive the paper

backward. You may need to press it a few times

until it stops, then you can pull out jammed sheets.

2. Do not insert more than 16 sheets of paper.

3. Do not insert materials that are too thick or too

rigid. Do not insert materials other than paper.

If possible, avoid using black or dark coloured

covers as the infrared sensor may not be able to

detect sheets being inserted into the machine.

The hole on the Staple Pusher should be hinged

onto the pin. Follow instructions on Page 3.

Follow instructions on Page 3 to put in the Staple

Pusher. The mark "26" should be shown towards

the rear of the machine and the Staple Head latch

should be locked.