Autonnic A4032 Manual del usuario - Página 7

Navegue en línea o descargue pdf Manual del usuario para Equipamiento marino Autonnic A4032. Autonnic A4032 16 páginas. Compass pick-up

Once this is operating the software can be used as follows:

Note that the [bracket] means the button on the screen of that name.

Connect the A4032 to the Autonnic Factory Utility

V1.12 with the correct port selected (see note

above) and use the [CONFIG] button to put a

command string into the send panel on the screen

which looks like this:

PATC,IIHDG,CFG,020

Make sure that the field is 020 as above – edit it

so that it does. Then press [SEND] so that the

message now uses the HDM format which you

can see in the scrolling window.

The press [SCI] and adjust the field at the end of the

command so it shows the calibration angle

interval you wish to use - usually 10 and then

press [SEND]

Close the port (but leave the program running) and

open the Calibration Tool V1.02. Open the correct

comm port to connect. Then adjust the Compass

so the needle is at 0.0 and adjust the A4032 by

rotating it so it too reads 0.0.

[START]

Click [Calibrate 0] and this button changes to

'Calibrate 10'. Turn the Compass so that it points

to 10deg and press [Calibrate 10] which then

changes to 'Calibrate 20' and so on. The output

of the A4032 appears on the screen but will not

exactly match the heading – that is purpose of

calibration.

Then press