iHeat Roof Mount Solar Hot Water Systems Manual de instalación - Página 7

Navegue en línea o descargue pdf Manual de instalación para Calentador de agua iHeat Roof Mount Solar Hot Water Systems. iHeat Roof Mount Solar Hot Water Systems 15 páginas.

Imprimir página

SECTION 2

Step-by-step Installation Guide

Installation Manual - Roof Mount Solar Hot Water - August 2017

Select rail location; insert straps through slots in rail

& screw to batten. For tile roof, attach strap directly

to truss and re-seat tile. Ensure panels have 8-10mm

collector slope from inlet to outlet. This slope must be

achieved to ensure correct level of thermosiphon.

TIP: For tin roof installations, double check the screws are

tightened firmly to avoid roof leaks.

Place first panel onto rail and ensure bottom of panel

is sitting flat on the rail. Ensure the 22mm panel unions

are connected to the first panel. Using two shifters, one

placed on the nut & one placed on the barrel of the

union, tighten the nut of the 22mm union to the 22mm

copper header pipe. DO NOT TWIST COPPER HEADER

PIPE AS THIS WILL CAUSE INTERNAL DAMAGE AND NOT

COVERED BY WARRANTY. Leave nut & olive on open

end for connection of the second panel.

Place second panel & ensure both panels are square.

Then gently slide both panels together and ensure

22mm copper header pipe is fully inserted into the

22mm panel union. Once both bottom and top 22mm

panel unions are fully inserted, using 2 shifters, place

one shifter on the nut & one shifter on the barrel of

the union and tighten the 22 mm nut. DO NOT TWIST

COPPER HEADER PIPE AS THIS WILL CAUSE INTERNAL

DAMAGE AND NOT COVERED BY WARRANTY.

Align panels to centre of the aluminium bottom rail

then screw the supplied 4 x Metal Self Tapping hex

head screws into the 4 x pre-drilled holes in bottom rail.

TIP: Now's a good time to clear to clear the roof space of

any obstacles for tank positioning.

1300 829 118

i-heat.com.au