Autopage RS-601 Manual de instrucciones - Página 3

Navegue en línea o descargue pdf Manual de instrucciones para Arranque a distancia Autopage RS-601. Autopage RS-601 9 páginas. Professional remote car starter with remote entry operation

Imprimir página

CHANGING THE BATTERY IN YOUR TRANSMITTERS XT-12:

The XT-12 transmitter uses two (2) 3 -volt lithium ion batteries (#CR2016)

that are sandwiched together with the (+) side facing upward. To replace

the battery, you will need to use a small flat blade screwdriver. Locate the

small notch on the lower right side of the transmitter case next to the key

ring. Using the flat blade screwdriver, carefully pry the top case from the

bottom case.

It should snap apart after breaking the seal.

Before

removing the batteries note the direction of the positive (+) terminal.

Place the new batteries in exactly the same manner, being careful not to

bend or damage the contact terminal. Snap the cases back together and

then test the transmitter to insure it operates the system.

Your RS601 remote car starter comes with a 2 XT-12 remote transmitters

with only two buttons. These remotes will be used in applications, where

the factory keyless entry system is the main source for arming/locking and

disarming/unlocking the vehicle. For example, vehicles with the factory

smart key/ "push button" start or one-piece remote with key, it is

recommended that the main sole purpose for this transmitter to be used for

remote starting the vehicle and remote entry when started by the RS-601.