Autopage RSTKE-900 Manual de instrucciones - Página 7

Navegue en línea o descargue pdf Manual de instrucciones para Arranque a distancia Autopage RSTKE-900. Autopage RSTKE-900 13 páginas. Professional 915 mhz remote car starter & 6 channel keyless entry system with two way serial port data link
También para Autopage RSTKE-900: Manual de instrucciones (9 páginas)

Imprimir página

TO REMOTE START THE VEHICLE:

When you want to start your vehicle,

1. Press

button once on the transmitter.

2. The parking lights will activate to indicate the remote start received

the signal.

3. The engine will start in approximately 5 seconds.

4. Once the engine is running and after couple seconds the parking

lights will turn on again and climate controls will activate and adjust the

vehicles interior temperature to your preset setting. (While the vehicle is

running, the "minutes" digit on the LCD screen will flash and will indicate

a count down timer based on the 5, 10, 20 or 30 minute run time set up

by your installation center.)

5. The vehicle will run for 5 to 30 minute cycle and automatically shut

down. (When the unit shuts off the count down timer will turn off and the

transmitter will play a melody sound.)

NOT E: The Remote Start Unit will not start the vehicle if any one of the

following conditions exists:

1. The hood is opened.

2. The brake pedal is pressed.

3. The remote start enable toggle switch is in the OFF position. (If

installed)

4. The gear selector is in any gear other then "PARK" or "NEUTRAL"

SAFE START (Child safety mode)

The factory default setting to start the vehicle is to press the

ONCE on the transmitter. Programming this feature to eliminate an

accidental remote start operation,

1. The user must press the transmitter

seconds to start the vehicle. or

2. The user must press the transmitter

time to start the vehicle.

TO OPERATE THE VEHICLE WHILE RUNNING ON THE REMOTE

START:

To operate the vehicle while the engine is running on the remote start:

1. Ins ert the ignition key and turn it to "ON" (not the start) position.

2. Press the brake pedal.

Note: If the brake pedal is pressed before the key is in the ON position,

the engine will shut down.

TEMPORARY STOP FEATURE:

(programmable)

button twice within 3

and

buttons at the same

button