Autopage AP4000EX Manual de instrucciones - Página 6
Navegue en línea o descargue pdf Manual de instrucciones para Alarma de coche Autopage AP4000EX. Autopage AP4000EX 17 páginas. Access point
También para Autopage AP4000EX: Manual de funcionamiento e instalación (15 páginas)
Imprimir páginaTHE AP4000EX WITHOUT AN ANTENNA WILL RESULT IN DAMAGE TO THE TRANSMITTER
PORTION OF THE SYSTEM. SUCH DAMAGE WILL NOT BE COVERED UNDER THE WARRANTY.
ANTENNA CONNECTION
1. If the existing car radio antenna is used, disconnect the vehicle's radio antenna cable from the radio. Plug the vehicle
antenna into the terminal of the AP4000EX main unit marked CAR ANTENNA. Plug the supplied coax jumper cable
into the terminal of the AP4000EX marked CAR RADIO. Plug the remaining end of the coax jumper into the vehicle's
radio.
2. If the vehicle is equipped with a fully automatic power radio antenna and you wish to use this antenna for the
AP4000EX, and optional relay must be used to automatically raise and lower the antenna during the paging cycle.
VEHICLE FULLY AUTOMATIC
POWER ANTENNA. (SEE NOTE #1 BELOW)
VEHICLE
ANTENNA
RELAY
CUT
VEHICLE RADIO
12 VOLTS CONSTANT
OPTIONAL
RK-1 RELAY
YELLOW (ANTENNA ACTUATOR CONTROL)
SUPPLIED
COAX
JUMPER
CAR RADIO
ANTENNA
NOTE #1 THIS ANTENNA MUST BE FULLY
AUTOMATIC FOR PROPER OPERATION.
READ THE MANUAL FOR OTHER WARNINGS
AND CAUTIONS.
CAUTION: DO NOT ATTEMPT TO CONNECT
MORE THAN ONE ANTENNA TO THE
TRANSMITTER.
[FIGURE 3]
6