Autopage RF-315 Manual de instalación - Página 3
Navegue en línea o descargue pdf Manual de instalación para Alarma de coche Autopage RF-315. Autopage RF-315 12 páginas. Professional vehicle security system
Imprimir páginaKeep wiring away from moving engine parts, exhaust pipes and high-tension cable. Tape
wires that pass through holes on the firewall to prevent fraying. Be careful of sharp edges
that may damage wires and causes short circuit.
CAUTION:
Do not connect the wire harness to the control module until all wiring to
vehicle is complete.
H1: MAIN 5 PIN WIRE HARNESS:
H1/1. RED / WHITE WIRE – PARKING LIGHT RELAY INPUT --
The RED/WHITE wire is the input to the flashing parking light relay. The connection of
the RED/WHITE wire will determine the output polarity of the flashing parking light relay.
If the vehicle you are working on has +12volt switched parking lights, you don't need to
connect this wire. This wire is already connected to +12volt.
If the vehicle's parking lights are ground switched, cut the RED/WHITE wire, and
connect the wire to chassis ground.
H1/2. WHITE WIRE -- PARKING LIGHT RELAY OUTPUT (+12V 15A OUTPUT) --
Connect the WHITE wire to the parking light wire coming from the headlight switch. Do
not connect the white wire to the dashboard lighting dimmer switch. (Damage to the
dimmer will result). The limitation of the white wire is 10 AMP max. Do not exceed this
limit or damage to the alarm and parking relay will result.
H1/3. BLACK WIRE -- SYSTEM GROUND –
This is the main ground connection of the alarm module. Make this connection to a solid
section of the vehicle frame. Do not connect this wire to any existing ground wires
supplied by the factory wire loom. Make the connection to the vehicle's frame directly.
H1/4. BROWN WIRE – (+) SIREN OUTPUT –
This is the positive (+) output connection for the siren. Current capacity is 2 amps.
Make connection to the (+) red wire from the siren. Connect the (-) black wire coming
from the siren to a good chassis ground.
H1/5. RED WIRE -- SYSTEM POWER (+12V CONSTANT) --
This wire supplies power to the system. Connect this wire to a constant +12 volt source.
H2: 4 PIN ORANGE CONNECTOR FOR 2 STAGE SHOCK SENSOR
Function: Allows easy positive, negative, instant trigger, and warn-away trigger connection
with quick disconnect ability for other detection devices.
WIRING
4. Green Wire / Warn Away Input
3. Blue Wire / Zone 4 Ground Trigger
2. Black Wire / Negative
1. Red Wire / +12Volts
3