ACTON BLINK BOARD Manual del usuario - Página 6

Navegue en línea o descargue pdf Manual del usuario para Accesorios ACTON BLINK BOARD. ACTON BLINK BOARD 9 páginas. Electric skateboard, belt drive

Also, follow these tips:

• Start by moving forward as slowly as possible

• Push the throttle in small increments.

• Keep a wide stance on the board

• Lean forward when accelerating.

• While braking, pull the throttle backward gently

B. Low Battery Warning/ Charging

When battery is low, a small speaker from the skateboard will beep several times as

a warning. However, sometimes you may not hear that sound. It is recommended to

ride carefully when you feel the motor is weak as it may shut down automatically. In

such cases, stop using Blink® and charge it with the provided charger.

The same beeping sound will come from the remote control when the battery is low

in the remote control. In the event that it does, stop using Blink® immediately as

riding performance can be extremely unpredictable while the remote tries to stay

connected to the board while the battery charge depletes.

ALWAYS CHARGE THE BATTERY AFTER IT DRAINS.

The battery must get charged immediately after it drains for long term battery

longevity. If the state of charge is allowed to remain below minimum for too long, it

may not be able to be recharged.

Charging the skateboard is indicated by the LED indicator on the charger. The LED

will turn from red to green as it ﬁ nishes charging. Charging the remote controller is

C. Sleeping mode

Blink® includes an energy saving mode- sleep mode-to prevent the battery from dying

if the user forgets to turn it o . After the system keeps idle for 5 minutes, both the

remote and the skateboard will go into energy saving/sleep mode. To reconnect the

two, both the board and the remote will have to be turned o . Do not alternate turning

them o and back on- make sure they are both o together and then turn them back on

after at least ﬁve seconds of o time.

the board is in normal operating mode or sleep mode. If the board remains on, the

battery charge will deplete.

Red = Charging