Autopage MA-200 Manual de instrucciones de instalación - Página 2

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Sistema de seguridad Autopage MA-200. Autopage MA-200 8 páginas. 2-way remote control motorcycle alarm
También para Autopage MA-200: Manual de instrucciones (13 páginas)

Imprimir página

We recommend insulating all your soldered or crimped connections with heat shrink or electrical tape. We

also recommend spraying silicone sealant on all your connections and plugs after they are connected and

plugged in, spraying beforehand prevents good electrical connections.

Keep wiring away from moving engine parts, exhaust pipes and high-tension cable. Tape wires that pass

through holes on the firewall to prevent fraying. Watch out sharp edges that may damage wires and cause

short circuit.

A. MOUNTING CONTROL MODULE:

Mount the control module with the tie-wraps or with the screws.

1. The control module and all of its components MUST be installed in a location where they cannot

become wet and be submerged in the water.

2. Keep it away from any heat sources or obvious leaks. Also keep the components and harnesses as far

from the exhaust as possible.

3. The higher the control module is mounted, the better the transmitter range will be.

B. MOUNTING THE SIREN: Optional

1. Place the siren in a location suitable for best sound results. Be careful not to mount the unit near

exhaust manifolds or other "hot" equipment and moisture area.

2. Mount it where a thief cannot easily disconnect it. Both the siren and its wires should be difficult to find.

This usually involves disguising the wire to look like a factory harness.

3. Preferred siren position is facing down so water does not collect in it.

4. When installing this system in watercraft, the siren must be mounted in a compartment that does not

take in water.

D. INSTALLING THE OVERRIDE/VALET/PROGRAM SWITCH:

The override/valet switch MUST be installed in a location where they cannot become wet and be

submerged in the water and in a hidden but accessible location. Drill a 1/4" hole at the location chosen and

use the nut and lock washer provided to secure the override/valet switch. Route this wire to the control

module.

C. INSTALLING THE LED STATUS INDICATOR:

1. The led indicator status should be visible from both side and rear of the motorcycle,

2. It need at least 1/2 inch clearance to the rear.

3. The LED fits in a 9/32 inch hole.

E. TRANSMITTER ANTENNA MODUL

Mount the transmitter antenna module with the tie-wraps or tape.

1. Keep the antenna module away from any heat sources or obvious leaks. Also keep the components and

harnesses as far from the exhaust as possible.

2. Mount the antenna module in a hidden but accessible location

3. Keep it away from large metal objects or chassis for best reception.

MA200 IN REV.A

INSTALLATION

Oct/23/2006