Galeski Polifox 1500 Manual de instrucciones - Página 5
Navegue en línea o descargue pdf Manual de instrucciones para Sander Galeski Polifox 1500. Galeski Polifox 1500 9 páginas.
Imprimir páginaGALESKI WERKZEUGE
ENGLISH
1. Specified Conditions of Use
The POLIFOX machines are designed for
using suitebale diamond tools for wet polish-
ing on marble, granite, ceramics and artificial
stone. They work with resin-based diamond
grinding discs or metal based diamond abra-
sive wheels or cups for squaring (edging)
and milling.
The machines are suitable under certain
conditions also for conventional abrasive
tools and methods which need high working
pressure with low (revolution-) speed.
The national (local) working safety rules (e.g.
Law on the Safety of Technical Appliances)
are applicable for its proper use. This electric
power tool developed by us is in strict con-
formity with legal requirements for technical
appliances, which are for the protection of
health and life during its use.
Do not use this product in another way as
stated for normal use.
2. Safety Advice
Read operating instructions thoroughly!
Observe safety instructions (see red in-
sert-sheet !)
• Do not pierce the motor housing, as this
could damage the double insulation (use
adhesives).
• Always pull the plug from the mains (power
supply) before making any settings or carry-
ing out maintenance.
• Only plug in when machine is switched off.
• Keep mains clear from working range of
the machine. Always lead the cable away
behind you.
• Before use check machine, cable and plug
for any damages or material fatigue. Repairs
should only be carried out by authorised
service agents.
• After switching off, the machine will not be
idle immediately. (After-running of the work
spindle.) Allow the machine to come to a
stop before putting down.
• Never reach into the danger area of the
machine when it is running.
Operating Instructions POLIFOX • ENGLISH
• Never allow children to use the machine.
• Always wear safety goggles and ear pro-
tectors when working with this machine. It is
further recommended to wear safety gloves,
apron, as well as sturdy non-slipping shoes.
• Only use tools approved for speed of at
least as high as the highest no-load speed of
the machine. (Must be approved for 3,600
r.p.m.)
• Pay attention to the dimensions of the
tools. Use only tools with suitebale thread
(M14 or 5/8 -11 UNC).
• Check grinding tools before use. The grind-
ing tool must be properly mounted and turn
freely. Do not use damaged, out-of-round or
vibrating grinding tools.
• Dust that arises when working in stones
with crystalline silicic acid can damage your
health. Do not work o any material contai-
ning asbestos. Please note the safety regu-
lations of the employer´s liability insurance
association.
• Immediately switch off the machine in case
of considerable vibrations or if other malfunc-
tions occur. Check the machine in order to
find out the cause.
• The workpiece must be fixed if it is not
heavy enough to be steady. Never lead the
workpiece to the grinding disk with your
hand.
• In case of extreme operating conditions
strong contamination can build up inside the
machine. In such cases it is recommended
to shorten the cleaning cycles.
• Be careful of hidden electrical lines or gas
and water pipes. Check the working area,
e.g. with a metal detector.
• Typically the A-weighted noise levels of the
machine are:
Sound pressure level: 87 dB (A)
Sound power level: 100 dB (A)
Wear ear protectors!
• Typically the weighted acceleration is
2
7 m/s
– 5 –