DCI Edge SERIES 5 Manual de instrucciones de instalación - Página 5

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Equipamiento dental DCI Edge SERIES 5. DCI Edge SERIES 5 11 páginas. Side delivery system
También para DCI Edge SERIES 5: Manual de instrucciones de instalación (12 páginas), Manual de instrucciones (8 páginas), Manual de instrucciones de instalación (14 páginas), Manual de instrucciones de instalación (13 páginas), Manual de instrucciones (19 páginas)

SITE PREPARATION

FIRST STEPS

Lay the installation template over plumbing stub-ups and check the position in the operatory.

Install air and water shut-off valves (not supplied).

Install 4 x 4 electrical connection box.

Mark the cabinet mounting points according to the template.

AIR

Pipe: 1/2" n.p.t. Protruding 1" from the floor. Supplied by contractor.

Air supply: pressure 80-100 psi. Air should be free from contaminants.

WATER

Pipe: 1/2" n.p.t. Protruding 1" from the floor. Supplied by contractor.

Water supply: pressure 40-80 psi. Water should be flushed clean before connecting to this equipment.

ELECTRICAL

Electrical: 4 x 4 x 2-1/4" Connection Box with 1/2" conduit knockouts.

Wire box as per local code with top of the box no higher than 4-1/2" above finished floor.

Voltage: 115 VAC, 3 wire, 15 or 20 amp with ground fault circuit interrupter (Series 5 cabinet only).

See "Electrical Outlets" Page 11

CENTRAL VACUUM

Pipe: supplied by contractor. Terminated with 5/8 OD tube protruding 1" from the finished floor.

GRAVITY DRAIN

Pipe: 5/8" OD tube protruding 1" from the floor. Place trap in-line and use vented fitting to conform to local codes.

Supplied by contractor.

WARNING: Ensure the cabinet is

properly grounded to protective earth.

CAUTION: Electrical utilities must be installed according to local codes and by a licensed electrician.

SERIES 4 & SERIES 5 12 O'CLOCK CABINET

WARNING: 3rd party x-ray systems must be

connected to a dedicated electrical circuit.

Installation Instructions