Autoplugin RCP-V2 Manual de instalación - Página 7

Navegue en línea o descargue pdf Manual de instalación para Electrónica del automóvil Autoplugin RCP-V2. Autoplugin RCP-V2 8 páginas. Volvo

Imprimir página

Connect both connectors to the module (X2 should be connected first)

Test the heater start from the module

Fix the module using double-sided adhesive tape

Install interior elements in the reverse order of removal

Adjust the module in the programming mode if it necessary. Make notes in

the programming table of the user manual about the adjustments

4) Troubleshooting

If you have problems with module operation, first of all check indication of the

built-in LED. LED blinks on for a 10 second after powering and then has to turn off

(CAN-bus have to be awoken). If a run-time error appears at heater startup, LED

indicates an error by flashings. The number of flashes corresponds to the error code.

See table 1 for the codes description and possible solutions.

Error

Code

Description

No answer

from the

heater

followed the

start

command

Battery level

is low

Possible Reasons of

Error Appearance

The heater is not

activated in the CIP

Outer temperature is

upper than +15 Celsius

degrees

Fuel level in the tank is

close to empty ("Fuel

Low" warning

indicator is lighting in

the CIP)

The heater is blocked

after 3 unsuccessful

starts

The module has

determined that the

battery voltage at the

heater startup or during

the heater operation is

below the specified

settings 3.1 и 3.2

Solutions

Configure the heater by Volvo

car dealer's equipment

The heater works only at

environmental temperatures

below +15°C. It is heater

manufacturer's restriction

Refuel the car

Try to start the heater from the

CIP's menu. If it not started to

burn, make diagnostics of the

heater.

Charge car's battery with

special charger (or start engine

to charge) or cancel 3.1/3.2

module's settings

Table 1