Autoplugin Therminal V2 Manual de instalación - Página 9

Navegue en línea o descargue pdf Manual de instalación para Electrónica del automóvil Autoplugin Therminal V2. Autoplugin Therminal V2 12 páginas.

Imprimir página

- Notifications are needed for the operation of Therminal application. If user sends

SMS manually, notifications can be turned off by the means of RCP settings 7.3.8

and 7.4.8, or via settings of GSM modem (see User Manual for details).

Troubleshooting

If a run-time error occurs with the heater, RCP Can will inform you by the built-in

and additional LEDs blinking about the error code. When Plug-n-Play cable is

used for connection, additional red LED is placed inside the housing of OBD-II

connector of Plug-n-Play cable and stays visible from the driver's side.

The number of LED's flashes corresponds to the error code. See table 4 for the

codes description and possible solutions.

Error

Code

Description

Wrong heater

configuration

Battery level

is low

Time limits

exceeded

Possible Reasons of

Error Appearance

The heater is not

activated in DIS

Outer temperature is

upper than +15 Celsius

degrees

Fuel level in the tank is

close to empty ("Fuel

Low" warning indicator

is lighting in DIS)

The heater is blocked

after 3 unsuccessful

starts

The module has

determined that the

battery voltage at the

heater startup or during

the heater operation is

below the specified

settings 3.1 и 3.2

Time limit for

autonomous operation of

the heater is achieved

(with active setting 1.1)

Solutions

Configure the heater by Volvo

car dealer equipment

The heater works only with

temperatures below +15°C. It

is the heater manufacturer's

restriction

Refuel your vehicle

Try to start the heater from

DIS menu. If it not started to

burn, make a diagnostics of

the heater.

Charge vehicle's battery with

special charger (or start engine

to charge) or cancel 3.1/3.2

module's settings

Run the engine or cancel 1.1

module's setting

Table 4