Autopot AQUAvalve 4Pot system Manuales de cuidados sencillos - Página 2
Navegue en línea o descargue pdf Manuales de cuidados sencillos para Césped y jardinería Autopot AQUAvalve 4Pot system. Autopot AQUAvalve 4Pot system 2 páginas.
Imprimir página
4Pot System Contents
• 1 x 12.4 Gallon Reservoir, Lid &
• 4x 1Pot Tray & Lid
1/4" Top Hat Grommet
• 4x 3.9 Gallon Pot
• 1x 1/4" Filter
• 4x AQUAvalve
• 4x 1/4" Tee Connector
• 4x Root Control Disc
• 2x 1/4" Cross Connector
• 1x 13' Length of 1/4" Pipe
• 2x 1/4" Inline Tap
Suggested Layouts
Layout 1
12.4 Gal
Reservoir
Layout 2
12.4 Gal
Reservoir
• P ot up your plants, water through, then allow your plants to establish in the pots for a period of 7 to 10
days before turning your system on. This will encourage a stronger and healthier root system.
• A lways raise your reservoir to a minimum of 6" above the highest AQUAvalve and re-fill the reservoir
when there is approximately a 1/3 of the water left - NEVER ALLOW THE RESERVOIR TO RUN EMPTY.
• F or the best results, we recommend mineral fertilisers. Do not use organic fertilisers, as they have a
tendency to block small pipe work.
• C lean all substrate from the bottom and sides of the pots before placing in each tray.
This will ensure your system is clean from the start.
• A lways use free draining substrates - further information of substrates or mixes of substrates can be found
on our website.
Plan views
and options
" pipe to the
Connect your 1/4
relevant fitting
1/4" Pipe
1/4" Inline Tap
1/4" Tee Connector
1/4" Filter
1/4" Top Hat Grommet
AQUAvalve
1/4" Cross Connector
Advice
I
www.autopot-usa.com
4Pot System Dimensions
13.8"
1
Place Root Control
Disc in 3.9 Gal Pot
(gold face down)
3
Remove collar
Push 1/4" Pipe through
collar and attach to
AQUAvalve nozzle
Rescrew collar - DON'T
over tighten... when
you feel it grip STOP
5
Position Tray
so it is level
7
8
Push 6mm Top Hat Grommet
Inside the Reservoir push
into Reservoir, then push
6mm Filter into 1/4" Pipe
1/4" Pipe through Grommet
Using your front instruction sheet, repeat the module setup instructions for the number of trays.
Allow your plants to establish for 7-10 days before turning the system on
If you require any guidance email: [email protected]
1Pot Module
14.7"
setup
instructions
12.4 Gal
Reservoir
11.8"
2
Fill Pot with substrate
Water through Pot
and allow to drain
4
Connect AQUAvalve
so 'half moon'
locates on T section
in the Tray
6
Cut
1/4"
Pipe
appropriate length
9
Place 3.9 Gal Pot in
the Tray, make sure
the pot is CLEAN!
Place black lid over
AQUAvalve
to