AutoPulse 4100-3111 Manual de instrucciones de instalación - Página 5

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Unidad de control AutoPulse 4100-3111. AutoPulse 4100-3111 10 páginas. Idnet 2 sprinkler card and idnet loop card

Imprimir página
4100-3113AR IDNet 2 Sprinkler Card, and 4100-3111 IDNet Loop Card Installation Instructions
Mounting
The IDNet 2 Sprinkler Card mounts onto the power distribution interface (PDI) in a sprinkler control panel expansion cabinet. You can also install the
sprinkler card in the expansion slot of an ES-PS card.
To mount the IDNet 2 Sprinkler Card Sprinkler Card, complete the following steps:
1.
Select an empty PDI connector. Insert the washer and the metal standoffs into the corresponding installation holes.
2.
Insert the PDI connector on the back of the card into the PDI connector.
3.
Use the provided hardware to secure the card.
To add an IDNet Loop card to a sprinkler card, complete the following steps:
1.
Remove the screws that attach the sprinkler card to the panel.
2.
Insert the metal standoffs and the plastic standoffs into the corresponding installation holes.
3.
Insert the connector on the back of the IDNet loop card into the connector on the sprinkler card, and snap it into place with the plastic
standoff.
4.
Use the provided hardware to secure the card.
Note: When adding IDNet Loop Cards to a pre-installed sprinkler card, it is important to update the properties of the sprinkler card in the sprinkler
control panel using the Autopulse Panel Programmer.
page 5
Figure 7: Mounting the IDNet 2 Sprinkler Card
Figure 8: Adding IDNet Loop Cards to a sprinkler card
579-1214AR Rev. B