HighGear Max Manual del usuario - Página 16

Navegue en línea o descargue pdf Manual del usuario para Pulsómetro HighGear Max. HighGear Max 19 páginas. Highgear pulseware duo heart rate monitor: user guide
También para HighGear Max: Instrucciones de inicio rápido (2 páginas)

Imprimir página

CARE AND MAINTENANCE

CARE OF THE WRIST UNIT

Your Pulseware heart rate monitor should be protected from shocks,

extreme heat and extended exposure to direct sunlight. As the owner

of the product you should only perform service procedures related

to the changing of the battery as shown in this manual. You should

NEVER attempt to disassemble or otherwise service your watch.

When not in use, your watch should be stored in a clean, dry area at

room temperature.

If your Pulseware heart rate monitor gets dirty it should be carefully

wiped clean using a moist cloth. Care should be taken when cleaning

the lens not to rub dirt into the surface as it can become scratched

and hard to read.

CARE OF THE HEART RATE TRANSMITTER

After every use you should rinse the transmitter strap and elastic

in warm fresh water and dry with a dry cloth. Do not store the

transmitter when wet as this may shorten the battery life. The

transmitter should be stored flat rather than folded and should never

be bent or stretched as this may damage the electrodes. Never lay

your heart rate transmitter on a metal surface, as this will quickly

drain the battery.

CARE AND MAINTENANCE

CHANGING BATTERIES IN THE WATCH

Pulseware heart rate monitors use a commonCR2032 3v Lithium

battery in both the watch and heart rate transmitter. These batteries

are commonly available at camera, bicycle, electronics and drug

stores. Normal battery life for the watch is approximately 1 yr.

NOTE: Heavy use of the Backlight system may significantly

reduce battery life.

A blank display or inaccurate heart rate readings are

indications that the battery is getting weak and should

be replaced.

1. Using a coin that closely fits the slot in the battery

door located on the back of the watch, turn the

battery door counter clockwise until the door

comes free of the watch.

2. Take care not to damage the O-ring seal for the

battery compartment and carefully remove the

old battery.

3. Place a fresh battery in the battery compartment

with the positive (+) side facing up.

4. With the O-ring in the proper position, place the battery door over

the opening and tighten it down by using a coin and turning in a

clockwise direction.

5. If the O-ring has been damaged, replace it before reinstalling

the battery door. Most jewelers and watch shops should have

replacement O-ring seals.

NOTE: Extreme care should be taken when replacing the

battery to ensure the unit remains fully water resistant. Failure

to properly replace the battery and correctly seal the unit may

cause the unit to become damaged and may void the warranty.

Lithium batteries of the type used in this watch are extremely

sensitive to improper storage. It is our experience that many of the

batteries being sold as new have been stored improperly and are

already dead or nearly dead when purchased. If you replace the

battery in your watch and it does not become functional, do not

assume there is something wrong with the watch. Try another battery

and see if that solves things, most of the time it will.