Gallagher C500615 Notas de instalación - Página 5

Navegue en línea o descargue pdf Notas de instalación para Instrumentos de medida Gallagher C500615. Gallagher C500615 8 páginas. Smb monitoring kit

3. Inserting the PSTN Dialer

The Gallagher PSTN Dialer is supported by the Gallagher Controller for both Contact ID

transmission and remote/PPP dial-up situations.

The dialer is housed in the same cabinet as the controller and is mounted on top of the

controller via the serial port. Secure the dialer to the controller using the 2 screws supplied.

With a dialer mounted on the controller, the controller's run LED is still readily visible.

4. Connecting the Wiring Loom

The wiring loom is used to join the Alula to the Dialer and the D8 module.

Alula

Connect the red to 12V, black to GND, wht/blue to RING, and blue/wht to TIP. Secure the

wireset tightly to the Alula's enclosure using the cable tie that is supplied in the wireset kit.

This acts as a strain relief.

PSTN Dialer

Connect the red to VIN, black to 0V, wht/blue to RING IN, and blue/wht to TIP IN.

D8 Module

Connect red to Out7 "+", and black to Out7 "-". Set jumper JP7 to position 2 (for 12V output

instead of position 1's 24V).

4. Setting Network Communication Path

Connecting via ethernet

Connect an ethernet cable from the Alula's ethernet port to the customer's network and

ensure the ethernet's LED is on.

Connecting via cellular

Verify the cellular LED is on and verify signal strength. A minimum of two signal bar LEDs is

recommended.