DCS DD-36-SS Manual de uso y mantenimiento - Página 5
Navegue en línea o descargue pdf Manual de uso y mantenimiento para Campana de ventilación DCS DD-36-SS. DCS DD-36-SS 10 páginas. The professional downdraft vent system
También para DCS DD-36-SS: Manual de uso y mantenimiento (10 páginas)
Imprimir página
USE & CARE INFORMATION
This vent system is designed
to remove smoke, cooking
vapors and odors from the cooktop
area.This
unit aHsohas severa[ features to insure operator
safety.
TO OPERATE THE DOWNDRAFT
Push the Up/Down
button
on top of the Downdraft
to raise the
pHenum as indicated.
The speed contro[
knob is [ocated on the
right
hand side of the pHenum.
Press the Up/Down
button
to
[ower the unit.
The Up/Down
button
must be pressed and heHd
momentariHy
to raise or [ower the pHenum. This is a safety feature
which
protects
against accidenta[
activation
when cleaning
the
pHenum. For best resuffs, start the Downdraft
before cooking
and
allow the unit to operate
for several minutes
after cooking
is
complete
to clear all smoke and odors from the kitchen.
If using
large
pots, place them
on the
rear burner
to insure
proper
ventilation.
A higher fan setting may be required.
Control
knob
CLEANING
The metal grease filters should
be cleaned
frequently
in hot detergent
solution
or washed
in the
dishwasher.
The plenum
and top strip should
be cleaned with stainless steel cleaner.
Abrasives and
scouring agents can scratch stainless steel finishes and should not be used.
USE WITH GAS COOKTOPS
The DCS Downdraft
Vent System is designed
for safe use with gas cooktops
and will not extinguish
burners or pilots. The blower
does not start operation
until the plenum
has reached the full upright
position.
Also, the blower stops operation
as soon as the Up/Down
switch is pressed to lower the unit.
WARNING:
If a spill occurs on the cooktop
that allows liquids to seep inside the Downdraft,
you must
turn the Downdraft
off immediately.
It is possible to cause damage
to the Downdraft
if water is allowed
inside the Downdraft
while it is operating.
[] Immediately
turn "OFF"the
Downdraft
at the speed control
located on the right hand side of
the Downdraft.
[] Turn'OFF"the
power supply to the Downdraft
at the circuit breaker box or fuse box.
[] Allow plenty of time for the Downdraft
to dry naturally.
Do not open the Downdraft
to remove
the water. Failure to follow these warnings
could result in damage to the Downdraft.
SAFETY MICROSWITCHES
This Downdraft
Vent System is designed
with a safety microswitch
behind the center of each grease
filter. These microswitches
prevent the blower and plenum-raising
mechanism
from operating
when
either of the grease filters is removed.
It is very important
to make sure that the grease filters are
properly
and firmly
in place after cleaning.
If the unit does not operate
after replacing
the grease
filters, make
sure the filters
are properly
installed
and are making
firm
contact
with
the safety
microswitches.