GALLERY STRETCHER-240 Manual de instrucciones - Página 15

Navegue en línea o descargue pdf Manual de instrucciones para Sistemas de enfardado GALLERY STRETCHER-240. GALLERY STRETCHER-240 17 páginas.

4. Rotate the artwork 180 degrees and repeat the process. Place the artwork back on

the stretcher plates in the "loaded position" and continue with the remaining

stretches.

Troubleshooting

Every machine leaves our facility fully assembled and tested, however, during transit it is

possible that the contents may have experienced some "sudden changes in motion", this

can lead to misalignment issues and even breakage. This section will attempt to resolve

some of the possible issues you may encounter with your machine.

Clamping Bar Not Closing

The Foot Pedal operates like a light switch; in this case it is air and not electricity. If your

foot pedal does not close please ensure that you have at least 90 psi from the compressor

and that it is going into the machine at the "green" quick-connect fitting.

Air is going to the machine but it is still not closing? Call us at 614-861-4582

Stretcher Bar is Hanging Up

In nearly every case this is caused during transit, the cylinders and their mounts are

"forced" out of alignment. This is best resolved over the phone.

If you are experiencing this problem please do not hesitate to contact us at 614-499-4989

and ask for Dave.

The Canvas is slipping during a stretch

The Clamping Bar is preset to 50 psi, located beneath the deck; this regulator should not

be tampered with unless you have been instructed by us to do so. Changing this setting

may cause severe damage to the Clamping Bar and will void your warranty. Do not

change this setting. Most stretches are done at no more than 30 psi; this will produce a

nice tight stretch with giclee canvas. Heavy canvas and oversized art may require more

pressure, but it should not exceed 50 psi. That is why we have preset the clamp to 50 psi

this will allow for a certain degree of "slip". If the clamp is preset to 50 psi and the

stretching pressure exceeds 50 psi, then there will be slipping.

Stretcher Bar is lifting when stretching

This is by design. Smaller artwork will tend to rise very easily and large artwork may not

rise at all, but that is fine. Typically, the artwork will rise about 3-4", as shown in the

photo below. The operator should not "push down" on the artwork in an effort to keep