COPERTINA inglese 0612 Instrucciones y advertencias - Página 12
Navegue en línea o descargue pdf Instrucciones y advertencias para Fabricador de hielo COPERTINA inglese 0612. COPERTINA inglese 0612 15 páginas. Automatic modular ice-cube maker
Imprimir página5.3.b DRAIN (Fig. 5)
Fix each water drain pipe (10) in the housing provided on the rear of the appliance. Make sure that:
• the pipe is a hose
• the internal diameter is 22 mm, as required
• the water drain hose is not throttled at any point throughout its length
• the drain hose slopes downwards by at least 15%
For water-cooled models with a daily production of 300 kg, connect union (16) to a drain with a
water drainage pipe (11).
It is advisable to drain the water straight into an open drain trap.
5.4 CONNECTION TO THE ELECTRICITY MAINS
‼
IMPORTANT:
models with daily production of 300 kg must be connected to a 32A interlocked receptacle
•
the appliance must be connected to the electricity mains by professionally qualified personnel in
•
accordance with the Manufacturer's instructions
before connecting the appliance to the electricity mains, make sure that the mains voltage rating
•
corresponds to the value indicated on the rating plate
make sure that the appliance is connected to an efficient earthing system
•
make sure that the capacity of the power supply system suits the maximum power value indicated
•
on the rating plate of the appliance
if the appliance comes supplied with a plug, prepare a socket controlled by an omnipolar circuit-
•
breaker (6 in Fig. 4), with a contact-opening gap of not less than 3 mm, in accordance with national
safety standards currently in force. This switch must be equipped with fuses, with the associated
residual current device positioned in such a way as to be readily accessible. Insert the plug into the
socket controlled by the switch
the plug must only be replaced by professionally qualified and authorized personnel, and the new
•
plug must comply with current national safety standards
if the appliance comes supplied without a plug and you wish to connect it permanently to the power
•
supply, prepare an omnipolar circuit-breaker, with a contact-opening gap of not less than 3 mm, in
accordance with national safety standards currently in force. This switch must be equipped with
fuses, with the associated residual current device positioned in such a way as to be readily
accessible. This operation must be carried out by a specialized technician
make sure that you fully uncoil the power supply cable and check that it is not crushed in any way
•
should the supply cable be damaged, it must be replaced by a specialized technician using a
•
special cable available from the Manufacturer or from the Technical Service Centres
5.5 CONNECTING THERMOSTAT TO BIN
The appliance is fitted with a thermostat, the probe of which must be connected to the bin if the
appliance is installed on a bin manufactured by us.
NOTE FOR INSTALLER:
This operation must only be performed by professionally qualified and authorized personnel.
To access thermostat probe:
• remove rear panel
• release and uncoil probe, taking care not to create any constrictions
• insert probe into hole in baseplate marked by a green arrow
• shape end of capillary tube as shown in Fig. 6 before inserting it into bulb-holding tube of bin, taking
care not to damage it
For further details, see the diagrams supplied with our bins.