Dynaudio BM 6A mkII Manual del usuario - Página 6

Navegue en línea o descargue pdf Manual del usuario para Altavoces Dynaudio BM 6A mkII. Dynaudio BM 6A mkII 15 páginas. Monitor system
También para Dynaudio BM 6A mkII: Manual del usuario (7 páginas), Manual del usuario (12 páginas)

Imprimir página

Setting Up

Mains Power Connections

Mains power is applied via a fused IEC inlet. The unit must be earthed. The voltage selector switch is used to

match the unit to the mains voltage in your territory. The mains fuse must be the correct value for the voltage

selected. 115 V requires a T3.15A fuse while 230 V requires a T1.6A fuse. The "T" signifies a slow blow type

fuse.

You must ensure that the correct voltage and fuse have been selected before switching the unit on.

Audio Connections

Audio input is via a female XLR connector. The input is electronically balanced with +ve on pin 2, -ve on pin 3 and

ground on pin 1. If your signal source is unbalanced it is usual to connect the unused signal pin (i.e. Pin 3) to

ground. This is normally done inside the connecting cable. For best results use only good quality screened cables

and connectors.

Positioning

The BM6A is designed primarily as a "nearfield" monitor and would normally be positioned 1-3 m from the listener.

It can be mounted on stands or on the meter bridge of the console (providing this is substantial enough). For best

results, the speakers should be "aimed" at the listener in both vertical and horizontal planes.

In any situation ensure that there is adequate space for ventilation around the heatsink.

BM User manual