DCS RGSC-305 Manual de instrucciones - Página 3

Navegue en línea o descargue pdf Manual de instrucciones para Gamas DCS RGSC-305. DCS RGSC-305 8 páginas. Lp/natural conversion kit for rgsc-305 professional range

Imprimir página

TO REPLACE THE VALVE BYPASS JETS:

1. Remove the control knobs from the valve shafts and thermostat.

2. Remove the four mounting screws from the corners of the valve panel.

3. Pull the panel forward over the valve stems.

4. Disconnect the wiring terminals at the light switch. Unsnap the indicator lights from the back of the valve

panel, being careful not to allow the lenses to fall from the face of the panel.

5. Remove the C-clips that retain the valve switches and slide the switches off of the valve shafts.

6. Locate the valve bypass jet in the valve body. Using a flat blade screwdriver, unscrew the bypass jets and

remove from valves.

Verify that the valve bypass jet sizes in the kit match the chart sizes and replace the valve bypass jets. Screw the

jet into the valve body until fully seated. Do not re-install the valve panel at this time.

VALVE ORIFICE (SIMMER)

LOCATION

SIZE

MARKING

ALL

0.57mm

STEP 3

CONVERT THE PRESSURE REGULATOR

WARNING

Do not remove the pressure regulator from the range.

To access the regulator, remove the kick panel, located below the range door. To convert the regulator from

Natural gas to LP gas or from LP gas to Natural gas, reverse the slotted plug in the regulator. See diagram.

Valve

VALVE

BYPASS JET

Orifice

NAT

RATE

SIZE

1700 Btu/hr 0.37mm

Reverse

Plastic Plunger

NAT

MARKING

RATE

1500 Btu/hr

NAT

Cap Screw

VALVE

SWITCH

(REMOVE)

VALVE

BYPASS JET