Dynaudio Xeo 30 Manual del usuario - Página 10
Navegue en línea o descargue pdf Manual del usuario para Altavoces Dynaudio Xeo 30. Dynaudio Xeo 30 18 páginas.
Imprimir página
Dynaudio Xeo 10/20/30
Fixing the
You can set the speaker to a higher volume using the function to fix the volume. This
setting also remains in effect in standby mode. If a signal source is connected to the
volume
Xeo 10/20/30 with its own volume control, you have the option to change the output
volume across a broad range with the signal source.
To fix the volume:
► Point the remote control at a speaker and press
fixing, press one of the two volume buttons.
Standby
To switch speakers to sleep mode:
► Point the remote control at a speaker and press
speakers.
– The speakers will enter sleep mode.
– The speakers also enter sleep mode if there is no audio signal for 20 minutes.
– In this mode, the wireless network is active and all connected units remain
synchronized.
– Sleep mode power consumption is <2 W.
To switch speakers to low-power standby mode:
► Press and hold
– The speakers go to low-power standby mode.
– In this mode, the wireless network is disabled and the speakers are not connected
to each other.
– Low-power standby mode power consumption is <0.5 W.
To turn off auto standby:
► Press and hold
18
for at least 2 seconds. To undo
or press
on top of one of the
on the remote control for at least 5 seconds.
on the remote control for at least 5 seconds.
Opt
Status LEDs on the front
The two LEDs in the upper left corner of the cabinet front indicate the operational state
of the speakers and system with various colours and blinking functions.
On-state Illuminated in blue
The speaker is switched on, connected to a Hub or Connect, and an
audio signal is played back.
On-state Slow blinking in blue
The speaker is switched on, connected to a Hub or Connect, but an
audio signal cannot be found.
On-state Illuminated in purple
The speaker is switched on, connected to a local input, and an audio
signal is played back.
On-state Slow blinking in purple
The speaker is switched on, connected to a local input, but an audio
signal cannot be found.
Connection Slow blinking in red
There is no active transmitter
Search Fast blinking in blue for 20 min
Searching for an active input.
Synchronization/
Fast blinking in red for 10 s
System synchronization during no transmitter
Connection
Blue LED is turned off for 0.2 s
New transmitter
Illuminated in red for 5 s
Receiver mode is changing.
Illuminated in white
Bluetooth connection is established.
Slow blinking in white
Speaker is in pairing mode.
Firmware loading White LED: slow to fast blinking
Firmware is being loaded.
during the load sequence,
Red LED: illuminated
Volume Fast blinking in blue
Volume is being adjusted.
Mute Fading in and out
Speaker is muted.
Off-state Illuminated dimly in red
Speaker is in standby mode.
1)
depending on the resolution of the audio source,
LED blinking code
off
Illuminated in
Illuminated in
white
a colour
Fixing the volume
/master or no connection possible.
2)
/master connection.
2)
ID, transmitter
input, or direct input is selected.
2)
2)
2)
Hub, Connect, mobile device, etc.
Slow blinking
Fast blinking
(1 or 2 Hz)
(3 or 4 Hz)
19