Emerson Bettis RTS Manual de instalación, uso y mantenimiento - Página 8

Navegue en línea o descargue pdf Manual de instalación, uso y mantenimiento para Equipamiento industrial Emerson Bettis RTS. Emerson Bettis RTS 18 páginas. Extension board for modbus rtu
También para Emerson Bettis RTS: Manual de servicio (18 páginas), Manual de instalación, uso y mantenimiento (16 páginas), Manual de instalación, uso y mantenimiento (18 páginas), Manual de instalación, uso y mantenimiento (16 páginas)

Section 2: Connection

November 2021

Connecting at the End of a Strand, Bus Termination

There is either no device connected to the bus in front or behind of the new Slave-Device.

Line configuration:

Figure 4

Bus termination:

Modbus RTU has to be terminated on both ends of every strand. Termination can be

accomplished through the termination resistor implemented in your RTS control unit. Bus

termination is activated when the respective switch on the connection board is switched to

"ON" as seen in Figure 4 (A. Single Channel).

2.2

Explosionproof Design

Normally, in explosionproof design, there is no termination available in the control unit.

That means, the bus termination must be done seperate outside of the control unit.

Optionally, a bus termination in the control unit is possible as well, this must be specified

by the order.

In this case, you can activate the bus termination by connecting the following terminals:

•

WARNING

The shield must be connected to the shielding connection clamp (windowcut), see Figure 5

or Figure 6.

Installation, Operation and Maintenance Manual

A. Single Channel

A with AT and B with BT (single channel version) or

A1 with A1T, B1 with B1T, A2 with A2T and B2 with B2T (dual channel version)

VCIOM-16741-EN Rev. 0

B. Dual Channel

Connection