Gallien-Krueger MB 800 Manual del usuario - Página 4
Navegue en línea o descargue pdf Manual del usuario para Amplificador Gallien-Krueger MB 800. Gallien-Krueger MB 800 11 páginas. Mb series
También para Gallien-Krueger MB 800: Manual del usuario (11 páginas)
Imprimir página
Safety Information
Please read all enclosed safety precautions before
connecting or operating this product.
Verify Line Voltage and Amperage
Your amplifier has been factory configured for
use with the specific line voltage for your location
only. For example, units set to operate within
countries that supply 100-120 volt electrical
service are not compatible with
systems used in other countries.
100-120 Volt/60Hz 15A circuit for
Canada.
220-240 Volt/(50/60Hz) 10A circuit for UK and
Australia.
220-240 Volt/(50/60Hz) 10 A circuit for Europe.
100-120 Volt/50Hz 15A circuit for Japan.
220-240 Volt/50Hz 10A circuit for Korea.
Proper AC circuit for all other countries.
Connecting
the
amplifier
specifications other than indicated above can create
safety and fire hazard, and may damage the
amplifier. If you have any questions about the
voltage requirements for your specific model, or
about the line voltage in your area, contact your
dealer before plugging the unit into a wall outlet.
Verify AC Circuit Capacity Before Use: The high
power output of your amplifier may require heavy
current draw under full-load conditions. To insure
proper performance and avoid potential safety
hazards, we recommend connection to line circuits
with amperage specified "as above". Connecting to
the same circuit used by other heavy power
devices, such as high wattage lights, may cause
circuit breakers to trip. It is always a good idea to
avoid using any audio equipment on the same AC
circuit as equipment
conditioners or refrigerators. This will lessen the
possibility of power variation and electrical start-up
noise affecting your sound.
Please
refer
to
instructions concerning installation.
MB 800
230-240 volt
USA and
to
a
line
with
with motors, such as air
page
9
for
more
AC Power Cord: To avoid safety hazards, use only
the power cord supplied with your unit.
replacement cord is needed, make certain to use a
standard IEC compliant cord.
cords should be replaced immediately. When
setting up, make certain that the AC plug is easily
accessible. If you do not intend to use the amplifier for
a considerable length of time, disconnect the plug
from the AC Mains Socket. Do not use an extension
cord.
Earth Grounding Connection: To prevent electric
shock, do not remove the grounding plug on the power
cord, or use any plug or extension cord that does not
have a grounding plug provided. Make certain that
the AC outlet is properly grounded as well. Do not
use an adapter plug with this product.
Do Not Open the Amplifier Enclosure: There
are no user serviceable parts inside this product.
Opening the amplifier enclosure may present a shock
hazard. Modification to the product will void your
warranty. If liquid enters the unit, or any metal
object such as a paper clip accidentally falls inside
the enclosure, disconnect the unit from the AC power
source immediately and consult an authorized
service station.
Setup: To insure proper operation and to avoid
potential safety hazards, place the unit on a firm, level
surface. Do not plug or unplug the instrument or
speaker cable while the amplifier power is on.
Heat & Ventilation: Make sure there is space
provided for proper ventilation. Avoid using in
extremely hot or cold locations and areas that are
exposed to direct sunlight or near heating equipment.
Avoid using in moist or high humidity areas.
10cm or 3.94"
required clearances
10cm
3.94"
NEVER BLOCK THE FAN VENT HOLES ON
THE SIDES OF THE UNIT!
4
Damaged power
rear
MB800
10cm
front
3.94"
If
a