Gallien-Krueger MB Fusion 800 Manual del usuario - Página 5

Navegue en línea o descargue pdf Manual del usuario para Amplificador Gallien-Krueger MB Fusion 800. Gallien-Krueger MB Fusion 800 12 páginas.

MB 500

Quick Start

The MB 500 amplifier is designed to be simple to operate. All controls have a well defined purpose.

These directions will take you through the basics and give you a good start for setting up your sound.

1. Plug it in:

Set the power switch to Off and connect the supplied power cord, from the amplifier AC receptacle, to

an AC power outlet of proper voltage and power rating (see safety information on page 5 for details).

2. Connect your cabinets:

Connect your speaker cabinets to the amplifier outputs marked Speaker. Use a two conductor or the

GK 4 conductor Speakon cable only.

Maximum Recommended Speaker Loads:

One 4 Ohm, or two 8 Ohm cabinets.

3. Initial front panel control settings:

Set all EQ controls and contour knob to 12 o'clock. Set the Input Volume, Master and Master B

controls at 0. The Boost knob should be set to 12 o' clock and the boost button (between Boost and

Master B konbs) in the out position.

4. Plug in your bass:

Using an instrument (shielded) cable, connect your bass to the Input jack and press the power switch

on. If you have active tone controls on your bass, turn all of the controls to the middle or flat position

and turn the volume all the way up. If you have conventional, passive tone controls, turn all tone and

volume controls all the way up.

5. Level and Master Volume settings:

Set the Master Volume to 3 o'clock. Turn the Input Volume knob up as you play to the desired output

level. If the clip light (pad button) flashes more than occasionally, press the -10db pad button in and

turn the Input Volume knob up. If it is still lighting often, try turning the volume down on your bass.

6. Boost/Master B:

Engage the button located between the Boost and Master B knobs. This will activate the Boost section

of the pre amp. This can also be done with the included foot switch. Turn up the Master B knob to the

desired volume level.*

You should be hearing your bass quite well through the Master and Master B channels. At this point

you can experiment with different EQ, Contour and Boost settings. Various sample settings can also be

found on page 8.

* It is recommended that the limiter is used for during high volume applications.