Galls Street Thunder ST280 Manual de instrucciones de instalación y funcionamiento - Página 10

Navegue en línea o descargue pdf Manual de instrucciones de instalación y funcionamiento para Amplificador Galls Street Thunder ST280. Galls Street Thunder ST280 20 páginas. Siren amplifier & light controller
También para Galls Street Thunder ST280: Manual de instrucciones de instalación y funcionamiento (18 páginas)

Galls Street Thunder ST280 Manual de instrucciones de instalación y funcionamiento
(Electrical Connections CONT'D)
Electrical Connections For Lighting Control
RED: (8 AWG) +12VDC Power -
The two large red wires exiting the back
of the siren should be connected to
+12VDC through a fuse rated for the
TOTAL current draw of ALL of the lights
controlled by this unit. They will supply
the power to the lights hooked up to the
9-pin connector. You must connect
BOTH red wires.
9-Pin Connector
(REFER TO THE LIGHT WIRE DIAGRAM ON
THE NEXT PAGE FOR PROPER WIRE SIZES!)
The electrical connections for slide switch
outputs, and for the push button light
functions outputs are located on the
square 9-pin connector (part #SWH-49)
on the back of the siren.
Empty
(Pin 1)
Empty:
(Pin 2)
Orange:
(Pin 3) L1 Output – This power output is activated when the slide switch
Yellow:
(Pin 4) S4 Output - Output power to lights controlled by S4 button.
Green:
(Pin 5) S2 Output - Output power to lights controlled by S2 button.
Blue:
(Pin 6) S3 Output - Output power to lights controlled by S3 button.
Violet:
(Pin 7) S1 Output - Output power to lights controlled by S1 button.
Gray:
(Pin 8) L2 Output – This power output is activated when the slide switch is
White:
(Pin 9) L3 Output – This power output is activated when the slide switch is
Testing -
Test all siren and light functions after installation to assure proper
operation. Test vehicle operation to assure no damage to vehicle.

ButtonLabel Insertion

Once the wire connections have been made to S1
through S4, labels can be inserted into the switches.
The product is shipped with 30 different labels for these
push buttons. Select the desired label inserts
(provided). Insert the label into each button and tuck
it under the lip of the switch.
3
2
1
6
5
4
9
8
7
Radio
Radio
PA
L1 L2 L3
S1 S2 S3 S4
is in the 1
st
, 2
nd
, or 3
rd
position.
in the 2
nd
or 3
rd
position.
in the 3
position.
rd
-8-
Thunder
Yelp
Manual
Horn
Wail
PA
HF
Manual
Speakers 1
2