Galmet SGS Fusion 100 Manual de instalación y funcionamiento - Página 3

Navegue en línea o descargue pdf Manual de instalación y funcionamiento para Suministros para calderas Galmet SGS Fusion 100. Galmet SGS Fusion 100 12 páginas. Layered tank for dual function gas boilers

Imprimir página

1. Operation and maintenance

1.1. Device description

The tank is protected against corrosion by a ceramic enamel burned at 850°C. A large magnesium anode is an additional protective element. The tank is

insulated with ecological polyurethane foam, which reduces heat loss to minimum. The outer housing is made from steel and is coated with powder paint.

This layer tank is designed for operation with a dual function gas boiler and storage of domestic hot water. The tank acts as a buffer loaded from the top with

warm water, which does not mix with the cold water occupying the bottom section of the tank. This solution greatly enhances the comfort of using a dual

function boiler, resulting in a large amount of heated water in a short time. Thanks to its layered water distribution, small water consumption does not start

the boiler too often. This prolongs its life and allows the user to save gas.

1.2. Technical characteristics

The main part of the device is the tank, in which the water is heated. The tank is made from a sheet of steel which is then enamelled with a ceramic enamel

on the inside part of the tank. The connections of the tank are closed with corks and all are located at the top cover.

1.3. Scheme

307 mm

165 mm

600 mm

Ø500

1. Operation and maintenance

1. cold water inlet

2. cold water outlet (to boiler)

3. sensor to control the pump

4. magnesium anode on a 5/4" cap (under the top cover)

5. circulation connector

6. connector for hot water from boiler

7. domestic hot water outlet

8. drain

9. 3-stage circulation pump

10. switch

11. thermostat

12. thermometer

13. 5/4" plug for electrical set

Installation and Operating Manual - SG(S) Fusion