CORAB ENCOR Manual de instalación - Página 3
Navegue en línea o descargue pdf Manual de instalación para Panel solar CORAB ENCOR. CORAB ENCOR 9 páginas.
Imprimir página
■ Work only under dry conditions, and use only dry tools.
Do not handle modules under wet conditions unless
wearing appropriate protective equipment.
■ When storing uninstalled modules outdoors for any
period of time, always cover the modules and ensure that
the glass faces down on a soft flat surface to prevent water
from collecting inside the module and causing damage to
exposed connectors.
Installation safety
■ Never disconnect electrical connections or unplug
connectors while the circuit is under load.
■ Contact with electrically active parts of the modules,
such as terminals, can result in burns, sparks and lethal
shock whether or not the module is connected.
■ Do not touch the PV module unnecessarily during
installation. The glass surface and the frame may be hot;
there is a risk of burns and electric shock.
■ Completely cover the module with an opaque material
during installation to prevent electricity from being
generated.
■ Do not work in the rain, snow or in windy conditions.
■ Avoid exposing cables and connectors to direct sunlight
and scratches or cuts in order to prevent insulation
degradation.
■ Keep children well away from the system while
transporting and installing mechanical and electrical
components.
■ Use only insulated tools that are approved for working
on electrical installations.
■ Do not wear metallic rings, watchbands, ear, nose, lip
rings or other metallic devices while installing or
troubleshooting photovoltaic systems.
■ Follow the safety regulations (e.g., safety rules for
working on electrical power plant stations) of your regions
and for all other system components, including wires and
cables, connectors, charging regulators, inverters, storage
batteries, rechargeable batteries, etc.
■ Under normal conditions, a photovoltaic module is likely
to experience conditions that produce more current
and/or voltage than reported at standard test conditions.
Accordingly, the values of Isc and Voc marked on this
module should be multiplied by a factor of 1.25 when
determining component voltage ratings, conductor
current ratings, minimum factor of fuse sizes, and size of
controls connected to the PV output. Rated values of
systems are selected based on temperature factors and
local weather conditions.
corab.pl
Installation manual
and safe operation instructions
of photovoltaic modules ENCOR
[ Does not apply to BIFACIAL modules]
■ Only use same connectors to connect modules to form a
string, or connect to another device. Removing the
connectors will void the warranty.
Fire safety
■ Consult your local authority for guidelines and
requirements for building or structural fire safety.
■ According to IEC 61730-2 standard, the modules have
been rated Fire Class C. W
■ When installing on the roof, the roof must be covered
with a layer of fireproof material adequate for this
application, and sufficient ventilation between the back of
the module frame and the installation surface must be
ensured.
■ Roof construction and installation may affect the fire
safety of the building. Improper installation may create
hazards in the event of a fire.
■ Use appropriate components such as fuses, circuit
breakers and grounding connectors as requires by local
authority.
■ Do not use modules near equipment or in locations
where flammable gases may be generated or collected.
Page 3 of 9