Galvamet Edge Instrucciones de instalación, uso y mantenimiento - Página 5
Navegue en línea o descargue pdf Instrucciones de instalación, uso y mantenimiento para Campana de ventilación Galvamet Edge. Galvamet Edge 17 páginas. 230-240 vac 50 hz
Imprimir páginaRemote control encoding
The supplied remote control is already encoded and can be used from
the beginning for the total control of the hood.
To encode another remote controls hold the button "P" on the hood for
4 seconds until the programming red LED lights up, at this point press
immediately after the On / Off engine.
When the red LED turns off, the programming is closed and you cannot
no longer program the remote control.
Charcoal filters maintenance alert
The electronic control report, after 100 hours of operation, with the
flashing of the LEDs, for 30 seconds at shutdown of the hood, the need
for cleaning of the grease filters.
To reset the counter, after cleaning the filters, while the flashing warning
press the "+" on the remote control until shutdown.
Safety switch
In case the remote control is lost or out of batteries, the appliance shall
be switched off pushing the "P" button.
MAINTENANCE
Always disconnect the hood from the mains before carrying out any
maintenance or cleaning operation.
Particular attention should be paid to the metallic anti-grease filters that
are designed to trap particles of fat contained in the fumes. The metallic
anti-grease filters must be washed at least once a month with detergent
in hot water (or in the dish-washer). The filters may discolour after a few
washes. This is normal and does not mean they have to be replaced.
To remove the metallic anti-grease filters open the bottom panel of the
hood and then remove the filter by the handle. Fig. 17
ATTENTION: the grease collected in the filters can easily catch fire and
it is therefore extremely important to clean the metallic filters on a
regular basis as per instructions.
The activated charcoal filters, if present, are designed to collect
unpleasant odours in the cooking fumes. The air is then released
purified in the environment. The charcoal filters must not be washed,
but replaced 2 or 3 times a year, depending on how much the hood is
used. New filters are to be requested directly to the manufacturer.
To replace the charcoal filters, just remove the motor protection panel,
centrally positioned between the metal filters: locking is performed with
magnetic closures; simply exert a modest manual force, without the use
of tools. At this point you can remove the active charcoal filter through
rotation of about 90 ° with respect to their position to unhook from the
locking lugs, accompanying then the filter downward, without the aid of
tools. Fig. 18-19-20-21.
To reinstall the new activated carbon filters, reverse operations.
In order to remove the remaining glue or any impurity, the cooker hood
must be cleaned immediately after installation and after having removed
the protective film.
The cooker hood must be cleaned frequently both internally and
externally (at least once a month).
Do not let dirt gather on the inner and outer surfaces of the hood.
To clean the exterior of the hood do not use either acid or basic
products, or abrasive sponges.
Clean the hood with a sponge dampen in warm water and a little
quantity of neutral detergent (for example dishwasher detergent), in
order to remove possible particles of grease.
Rinse with a damp cloth, removing all the detergent carefully, following
the satin finish direction on the steel surface.
Drying is very important, especially in areas where water is particularly
hard and leaves limestone.
The hood features a LED light that, in addition to offering a good
lighting and a significant energy savings, are guaranteed to last on
average 10 times more than traditional lights. For replacement, contact
the Assistance Service.
All the ordinary and extraordinary maintenance can be performed
without having to remove the hood.