Galvin Engineering GalvinAssist 41985CP Manual de instalación - Página 3

Navegue en línea o descargue pdf Manual de instalación para Ayuda para el baño Galvin Engineering GalvinAssist 41985CP. Galvin Engineering GalvinAssist 41985CP 5 páginas. Cp hand shower with inverted lh t 700x1100 ss hygienic grab rail

Imprimir página

Product Installation Guidelines

INSTALLATION

INSTALLATION COMPLIANCE: Galvin Engineering products must be installed in accordance with these

installation instructions and in accordance with AS/NZS 3500, the PCA and your local regulatory

requirements. Water and/or electrical supply conditions must also comply to the applicable national and/or

state standards. Failing to comply with these provisions shall void the product warranty and may affect

the performance of the product.

WARNING: Install with stainless

steel 304 or 316 screws. Other

type of screws may rust and void

warranty.

1. Install straight grab rails including the

horizontal section of any grab rail as per

AS 1428.1, 800-810mm from floor to top

of rail. Make sure the wall surface is flat

and free from contaminants.

3. Remove flange protector from grab rail

flange. Align guide lug marks from step 2

and mark wall through base holes to

pinpoint screw holes.

When marking out these grab

rails, use centre base holes of

flange protector.

2. For STRAIGHT grab rails, position the

4. Fit dress ring if applicable. Drill spot

Version 1, 25

Version 1, 1 June 2022, Page 3 of 5

When marking out corner grab

rails follow the fixing guide lug

diagram shown above to suit grab

rail orientation

flange protector guide lugs either vertical

or horizontal.

marks with 7mm bit. Screw wall mount

plate to wall. Ensure screws engage wall

stud or other solid substrate.

May 2022, Page 3 of 5