AGS Merlin 1500S Manual del usuario - Página 4

Navegue en línea o descargue pdf Manual del usuario para Control Panel AGS Merlin 1500S. AGS Merlin 1500S 12 páginas. Gas & ventilation interlock system
También para AGS Merlin 1500S: Manual de uso e instalación (8 páginas), Manual de instalación y funcionamiento (12 páginas)

Imprimir página

Merlin 1500S

Circuit Board Terminals

2.1

LINE VOLTAGE

A 110-120VAC electrical supply should be externally fused at

3A and connected to the terminals marked [LINE VOLTAGE

LNE].

2.2

VALVE OUT

The 110-120VAC gas solenoid valve should be powered using

the terminals on the Merlin 1000S detailed [VALVE OUT LNE].

2.3

SUPPLY FAN & EXTRACT FAN PD SWITCHES

These terminals are used to receive an input signal from external air pressure switches or external

current monitors. These are linked out as a factory setting as shown.

2.4

BMS OUT

Terminal connections are available on the circuit board for connections to

Building Management systems.

This is a relay that changes state in alarm or when gas is on/off and can be

used in conjunction with the [12VDC] output and other external relays that

affect other devices and controls such as purge fans, audible alarms etc.

Detailed on the circuit board as [BMS OUT] normally closed (N/C),

common (COM) and normally open (N/O). These are volt free connections.

2.5

The terminal for remote emergency shut-off buttons is detailed on the circuit

board as [EM REMOTE].

These connections are linked out as a factory setting.

Remote emergency shut-off buttons should be volt free and wired to the Merlin

1500S using a plenum security cable, white, 18/2 (18AWG 2 conductor),

stranded, CMP or similar.

Rev: 07

05-19

Wiring to switches & current monitors should be made using

two-core volt free connections.

If only one fan is being used the terminals not in use should be

left linked out.

EM REMOTE

User Guide