HIKOKI DH 36DMA Manual de instrucciones de manipulación - Página 10
Navegue en línea o descargue pdf Manual de instrucciones de manipulación para Herramienta eléctrica HIKOKI DH 36DMA. HIKOKI DH 36DMA 20 páginas.
Imprimir página
NAMES OF PARTS (Fig. 1 – Fig. 20)
Drill bit
1
Stopper
2
Selector lever
3
Switch trigger
4
Handle
5
Nameplate
6
RFC indicator lamp
7
Rotation speed
8
selector switch
Display lamp
9
Battery
0
Tail cover
!
Housing
@
Motor
#
Side handle
$
Grip
%
Front cap
^
Stopper lever
&
Latch
*
Charge indicator lamp
(
SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
DH36DMA: Cordless Rotary Hammer
To reduce the risk of injury, user must read
instruction manual.
Direct current
V
Rated voltage
n
No-load speed
0
/min
Oscillation per minute
Bpm
Full-load impact rate
φ
Drilling diameter, max.
max
Weight
(According to EPTA-Procedure 01/2003)
kg
Drill bit
Core bit
Adjustment of the tool position function
Hammering only function
Rotation and hammering function
Remaining battery
)
indicator switch
Remaining battery
q
indicator lamp
Display panel
w
Grease
e
Wing bolt
r
Taper shank adapter
t
Drill bit (Taper shank)
y
Cotter
u
Core bit shank
i
Core bit
o
Guide plate
p
Center pin
a
Core bit tip
s
Battery sliding
d
grooves
Terminal
f
Rubber cover
g
USB port
h
USB cable
j
Switching ON
Switching OFF
Rotation speed selector switch
Display lamp
Ls
Low speed / impact rate
Hs
High speed / impact rate
Disconnect the battery
Lights ;
The battery remaining power is over 75%
Lights ;
The battery remaining power is 50% – 75%.
Lights ;
The battery remaining power is 25% – 50%.
Lights ;
The battery remaining power is less than 25%
Blinks ;
The battery remaining power is nearly empty.
Recharge the battery soonest possible.
Blinks ;
Output suspended due to high temperature.
Remove the battery from the tool and allow it to
fully cool down.
Blinks ;
Output suspended due to failure or malfunction.
The problem may be the battery so please
contact your dealer.
Warning
STANDARD ACCESSORIES
In addition to the main unit (1 unit), the package contains the
accessories listed on page 16.
Standard accessories are subject to change without notice.
APPLICATIONS
Rotation and hammering function
○ Drilling anchor holes
○ Drilling holes in concrete
Hammering only function
○ Crushing concrete, chipping, digging, and squaring
(Some applications need optional accessories)
SPECIFICATIONS
The specifi cations of this machine are listed in the Table on
page 16.
NOTE
○ Existing batteries (BSL3660/3626X/3626/3625/3620,
BSL18xx and BSL14xx series) cannot be used with this
tool.
○ Due to HiKOKI's continuing program of research and
development, the specifi cations herein are subject to
change without prior notice.
10