Corbin Russwin CL3380 Instrucciones de instalación - Página 2
Navegue en línea o descargue pdf Instrucciones de instalación para Cerraduras Corbin Russwin CL3380. Corbin Russwin CL3380 4 páginas. Grade i key-in-lever cylindrical lockset
Imprimir página
Door & Frame Preparation
Mark door
Locate and mark horizontal center line at desired height above
floor. Fold template over edge of door, centering on horizontal
line. Mark centers of holes at proper backset.
of the door.
Note:
Be sure to verify backset before marking & drilling door.
Drill door
2-1/8" (54mm) hole thru door. Cut ANSI tab notches
A.
as shown on template (except CL3350 and CL3370).
Drill 1" (25mm) hole in edge of door. Cut out for
B.
latch front 5/32" (4mm) deep. 1-1/8" (29mm) wide
x 2-1/4" (57mm) high. Check latch unit for proper
width front and square or round corners
(except CL3350 and CL3370).
C.
Drill two (2) 11/32" (8mm) Dia. holes through door
for all functions.
Caution:
To avoid splintering wood doors, drill holes from both sides.
Install Strike
Adjust Lock for Door Thickness
Adjust lock to door thickness if other than 1-3/4"
(44mm) doors
A. Remove outside lever (see page 4)
Mark both sides
B. Slide off outside cassette assembly.
C. Rotate rose liner to adjust lock to fit door thickness, so
D. Re-assemble outside cassette assembly onto chassis
(2)
(Lock pre-set from factory for 1-3/4" door).
*
.
that the distance (Dim. "A") from the inside of the liner to
the centerline of the retractor is one half of the thickness
of the door (see chart).
assembly (except CL3380 and CL3381 functions).
*
Note: For doors more than 2", verify
lock package is labeled with "D214" option.
Door
Thickness*
1-3/4"
2"
2-1/4"
"A"
7/8"
1"
1-1/8"