aireRyder F0064 Manual - Página 6

Navegue en línea o descargue pdf Manual para Ventilador aireRyder F0064. aireRyder F0064 8 páginas.

Imprimir página

Mounting Plate

Screw

Lock Washer

Canopy

Fig.8

Position both slots on the canopy directly

under and in line with two screws and

lock washers in the mounting plate. Lift

the canopy, allowing the two screws and

lock washers to slide into the mating slots.

Rotate the canopy counterclockwise until

both screws from the mounting plate drop

into the slot recesses. Tighten screws

securely. Install the other two screws and

lock washers into the mating holes of the

mounting plate and tighten to secure the

canopy to the mounting plate.

Fan Light Installation:

WARNING:

As per EPACT 2005 requirements, this fan light has a built-in current limiting device in the receiver of remote control to

conserve energy. The fan light will not be brighter when you press dimmer button if the combined wattage of the

installed bulbs exceeds 190 Watts.

Fig.10

Install

Fan Light

Fig.12

Install the glass shade by screwing it

onto the central fan fixture. (Make sure

the glass shade is securely attached,

but DO NOT over tighten.)

Fan Light

Fig.9

Insert the fan blade through the slot

on the fan fixture set.

and fasten fan blade to the fan

fixture set with screws. Repeat for

remaining fan blades.

Fig.11

Make wire connection. Plug the male

connector from the motor into the female

connector from the LED Module .

Carefully put the wires into the switch box.

Secure the LED Module up to the bottom

of the motor with LED Module screws.

Fig.13

Turn ON the electric power at the

main fuse or circuit breaker box.

PAGE: 6 / 8

Fan Fixture Set

Fan Blade

Blade Screw

Male Connector

Female Connector

LED Module

LED Module Screw

181008