HIKOKI G 10ST Manual de instrucciones de manipulación - Página 12
Navegue en línea o descargue pdf Manual de instrucciones de manipulación para Amoladora HIKOKI G 10ST. HIKOKI G 10ST 20 páginas.
Imprimir páginad) Use special care when working corners, sharp edges
etc. Avoid bouncing and snagging the accessory.
Corners, sharp edges or bouncing have a tendency
to snag the rotating accessory and cause loss of
control or kickback.
e) Do not attach a saw chain woodcarving blade or
toothed saw blade.
Such blades create frequent kickback and loss of
control.
SAFETY WARNINGS SPECIFIC FOR
GRINDING OPERATION
a) Use only wheel types that are recommended for
your power tool and the specific guard designed
for the selected wheel.
Wheels for which the power tool was not designed
cannot be adequately guarded and are unsafe.
b) The guard must be securely attached to the power
tool and positioned for maximum safety, so the
least amount of wheel is exposed towards the
operator.
The guard helps to protect operator from broken
wheel fragments and accidental contact with wheel.
c) Wheels must be used only for recommended
applications. For example: do not grind with the
side of cut-off wheel.
Abrasive cut-off wheels are intended for peripheral
grinding, side forces applied to these wheels may
cause them to shatter.
d) Always use undamaged wheel flanges that are of
correct size and shape for your selected wheel.
Proper wheel flanges support the wheel thus
reducing the possibility of wheel breakage. Flanges
for cut-off wheels may be different from grinding
wheel flanges.
SPECIFICATIONS
Model
1
Voltage (by areas)*
1
Power Input*
Rated Speed
Wheel size
external dia.
thickness
hole dia.
2
Weight*
*
1
Be sure to check the nameplate on product as it is subject to change by areas.
2
*
Only main body.
11
e) Do not use worn down wheels from larger power
tools.
Wheel intended for larger power tool is not suitable
for the higher speed of a smaller tool and may
burst.
SAFETY WARNINGS SPECIFIC FOR SANDING
OPERATIONS
a) Do not use excessively oversized sanding disc paper.
Follow manufacturers recommendations, when
selecting sanding paper.
Larger sanding paper extending beyond the sanding
pad presents laceration hazard and may cause
snagging, tearing of the disc or kickback.
PRECAUTIONS ON USING DISC GRINDER
1. Never operate these power tools without Wheel
Guards.
2. Use only a depressed center wheel of permissible
peripheral speed 72 m/s (4300 m/min) or more.
3. Correct use for safe operation.
4. Mounting the standard depressed center wheel.
5. Have a trial run before grinding commence.
6. Keep away from a revolving depressed center
wheel.
7. Pay strict attention to sparks.
8. Do not leave the revolving Grinder unattended on
the floor.
9. Follow the procedures of these Handling Instructions
on depressed center wheel replacement.
10. Avoid overload operation.
11. Do not push in the lock pin while the spindle is
running.
12. Be careful those around one while operating.
G10ST
(110V, 220V, 230V, 240V)
720 W
12,000/min
Max. Peripheral Speed: 72 m/s (4300 m/min)
100 mm
4 mm, 6 mm
16 mm
1.5 kg
50/60 Hz