GAME NS6028 Manual del usuario - Página 6

Navegue en línea o descargue pdf Manual del usuario para Calentador de piscina GAME NS6028. GAME NS6028 13 páginas. Curve heater

INSTALLATION INSTRUCTIONS

Heater – Filter – Pool Layout

The system layouts below will help you install the solar heater(s) to your above ground pool.

BEFORE INSTALLING SOLAR HEATER

AFTER INSTALLING SOLAR HEATER

1. Solar Heater Placement

Extend the two legs on the underside of the heater and face the heater in the direction of the sun's natural path. See Figure 1.

Heater - Pool Connections

These instructions assume that the pool and filter system are already assembled

and there is a hose attached to the pool return (pool water inlet).

Place the solar heater in a location where it will receive the greatest amount

of sunlight and at least 10 feet away from pool.

2. Heater - Filter Pump Connection

a) Turn off filter pump.

b) Block water flow at both the pool return inlet and the filter pump outlet

to prevent water from flowing through the hoses.

c) Detach the pool return hose from your filter system and set aside.

d) Depending on the orientation of your pump setup and desired heater placement,

choose one side to be the inlet and the other to be the outlet.

e) Locate long filter hose and attach between pump (the port where the pool return

hose was previously connected.) and the inlet using the included hose clamps .

NOTE: Depending on the size of your hose, the 1¼"-1½" reducer may ne needed.

Insert the reducer inside of the filter hose and attach using hose clamp. Apply a

small amount of silicon based lubricant to the outside of the reducer to allow an

easy fit.

SAVE THESE INSTRUCTIONS

NOTE: Not shown to scale

Leg

Foot

Figure 1