Deagostini Model Space HUMMER H1 Manual - Página 13

Navegue en línea o descargue pdf Manual para Juguete Deagostini Model Space HUMMER H1. Deagostini Model Space HUMMER H1 18 páginas.

HUMMER H1: STEP BY STEP

9 9

Tighten with a screwdriver,

but only up to the point

where the linkage base

can still be rotated slightly.

Push the throttle linkage

rod through the linkage

base until the spring fitted

in Step 13 rests against the

side of the linkage base.

Place a 2mm washer over

the protruding tip of the

screw at the other side of

the linkage base.

Prepare the throttle

linkage rod assembly

from Step 1, and slide the

throttle spring (Stage 46)

over the free end of the

rod.

Make sure that the screw

is loose enough that you

can move the linkage base

back and forth a little, but

tight enough to stop the

part rattling.

Use scissors to cut the

silicon tubing kept from

Stage 43 in half.

217

Making sure the washer

and screw do not fall out,

place the tip of the screw

into the circled hole on

the side of the servo horn.

Making sure the spring

does not fall off, insert

the free tip of the rod into

the hole in the side of the

linkage base.

™