Dean Sherford Slimline 5 Manual de instrucciones - Página 4

Navegue en línea o descargue pdf Manual de instrucciones para Estufa Dean Sherford Slimline 5. Dean Sherford Slimline 5 17 páginas.

When the fire has fully established and the logs are burning well shut the primary air comtrol

and control the fire with the secondary air wash lever (if you are unable to sustain the fire with

secondary control it is very likely that your logs have a high moisture content).

Refuelling

When refuelling the fire, to ensure clean burning, the primary air control should be opened for

a couple of minutes so that flames are established on the newly fuelled logs. The primary air

should then be closed (pushed fully in) and the secondary air adjusted to create the desired

flame pattern once these flames are established and the logs have become blackened.

After refuelling, it is recommended that you do not leave the appliance unattended until it is

certain that the logs are burning well with a sustained flame.

Do not load the fuel above the log retainer.

Please note:

If there is insufficient burning material in the fire bed to light a new fuel charge, excessive

smoke emission can occur. Refuelling must be carried out onto a sufficient quantity of glowing

embers and ash that the new fuel charge will ignite in a reasonable period. If there are too few

embers in the fire bed, add suitable kindling to prevent excessive smoke

Fuel overloading

The maximum amount of fuel specified in this manual should not be exceeded, overloading

can cause excess smoke.

The door should always be closed between refuelling to prevent fumes and spillage from the

firebox.

When loading the fire be careful not to leave logs projecting over the log retainer as you may

crack the glass when closing the door.

The ash should be removed before it reaches the primary air holes (approximately 25mm down

from the bottom edge of the door aperture) which are situated along the inside front edge of the

fire box. Always leave about 10mm on ash in the stove, this will help a new fire establish when

next lighting the stove.

In the summer or when the stove is not being used for a long period of time, clear all the ash

out and leave primary and secondary air vents open to prevent condensation.

Please Note:

When lighting the stove for the first time the paint on the stove will cure and give off a metallic

smell. It is advisable to ventilate the room ie. open the windows. This will subside after the

stove has been burning hot for at least 2 hours.

The appliances have been assessed and are suitable for intermittent burning.

with the door open can cause excess smoke. The appliance must not be operated with

Operation

the appliance door left open except as directed in the instructions.