Jafar 2002 Manual de instrucciones - Página 8

Navegue en línea o descargue pdf Manual de instrucciones para Unidad de control Jafar 2002. Jafar 2002 8 páginas. Flanged gate valves with soft seals



Clean and moisten the seat in the cover.



Install the new sealing plug assembly (2) or clean the existing one and install its new o-rings.



Leak test the valve in the OPEN POSITION to confirm that the sealing has been properly replaced.



Install the circlip in place to prevent secure the plug (1) in place.



The reassembled and positively tested valve will be ready for operation.

7. SAFETY

All installation and operation tasks related to the product shall be only be done by qualified professionals with

sufficient training and experience to assess the current situation and identify and avoid hazards. Failure to follow

this warning or this Operating Manual may cause death, severe bodily injury or substantial property damage.

Fabryka Armatur Jafar S.A. shall not be liable for any accidents or emergencies related to incorrect installation or

operation of the product. Note that the valve installation could be pressurized or contain various type of stray gas

or aggressive liquids. If the installation is operated explosion hazard zones, ATEX requirements may apply; this

will require suitably trained professionals (according to ATEX requirements). Do not use tools which may generate

electrostatic discharge in the ATEX zone.

Do not use the product without thorough knowledge and understanding of this Operating Manual. Follow the

general health and safety rules. Keep this Operating Manual throughout the service life of the product to ensure a

safe operation of the latter.

The product assembled, installed and operated in compliance with this Operating Manual and the Product

Specification Sheet is covered by a commercial warranty from the manufacturer. The warranty terms, conditions

and period are specified in the Warranty Certificate available from www.jafar.com.pl.

The manufacturer may provide this product with custom materials and modifications on order. The final selection

of the product which meets the optimum criteria for the installation project in question is made by the installation

designer, who should consider this Operating Manual along with other data and information of significance for the

correct operation of the product.

Failure to comply with the guidelines and instructions in this Operation and Maintenance Manual releases the

manufacturer from all obligations, liability and warranty. Due to continuous business development, the

manufacturer reserves the right to modify and change the design of the product shown herein.

OPERATING MANUAL

06-2021

8/8