GamerModz SPS?X1 Manual de instrucciones - Página 2

Navegue en línea o descargue pdf Manual de instrucciones para Enrutador de red GamerModz SPS?X1. GamerModz SPS?X1 4 páginas. Ps4

Your GamerModz SPS‐X1 Controller comes with 1 Programmable Rapid Fire Mode. To program rapid fire, you

must first have rapid fire enabled (Reference "Turn On/Off Rapid Fire Quickly" on Page 1).

Once Rapid Fire is enabled, follow the instructions below to Program your shots per second. Your GamerModz

Controller will remember the settings even after you turn your controller off.

Programming adjustable Rapid fire modes

Once you have Rapid Fire Enabled, Hold Down the Right Trigger , then Hold Down Right on D‐Pad

until the main LED begins to flash. Release both the Right Trigger and Right on D‐Pad .

Hold

Once in Programming Mode you can adjust your shots per second by Tapping Up on D‐Pad to Increase

Shots per Second and by Tapping Down on the D‐Pad to Decrease Shots per Second. Note: Each time

you Tap the D‐Pad, your Rate of Fire will Increase or Decrease 1 Shot per Second.

To test the Rapid Fire Rate, fire your weapon by pulling the Right Trigger . Adjust your Rapid Fire Rate by

Tapping Up or Down on the D‐Pad until the desired smoothness and rate of fire is achieved. Please

see graph on Page 4 for Reference.

Once you have the desired Rapid Fire Setting, Tap Right on D‐Pad to lock in the rate of fire. The PS4 LED

will flash the number times corresponding to your rate of fire and then go Solid. For Example: 12 Shots per

Second, The LED will flash 12 times, then go solid.

= Increase Rate of Fire

GamerModz

Adjustable rapid

Fire Mode

, then

PS4 – SPS-X1 Ver 2.0

Hold

Until LED

, then

Begins to Flash

= Decrease Rate of Fire

Release

= Lock Rate of Fire