CentralPneumatic 61718 Manual del usuario - Página 10

Navegue en línea o descargue pdf Manual del usuario para Destornillador de impacto CentralPneumatic 61718. CentralPneumatic 61718 16 páginas. 1/2" air

Imprimir página
Operating Instructions
R ead th e ENTIR E IMP OR TANT SAFETY INFOR MATION section at th e beg inning of th is
m anual including all tex t under subh eading s th erein bef ore set up or use of th is product.
Inspect tool bef ore use, look ing f or dam ag ed, loose, and m issing parts.
If any problem s are f ound, do not use tool until repaired.
Tool Set U p
TO P R EV ENT SER IOU S INJU R Y FR OM ACCIDENTAL OP ER ATION:
Turn of f th e tool, detach th e air supply , saf ely disch arg e any residual air pressure
in th e tool, and release th e th rottle and/ or turn th e sw itch to its of f position bef ore
perf orm ing any inspection, m aintenance, or cleaning procedures.
TO P R EV ENT SER IOU S INJU R Y :
Do not adj ust or tam per w ith any control or com ponent in a w ay not specif ically ex plained w ith in
th is m anual. Im proper adj ustm ent can result in tool f ailure or oth er serious h az a rds.
1. Push the Control Valve forward so that the end
of the Valve protrudes out above the Trigger
for clockwise ("forward") tool operation.
2. Push the Control Valve back so that the end of
the Valve protrudes from the back of the Housing
for counterclockwise ("reverse") tool operation.
3. Adjust air flow by pushing down Air Regulator and
turning knob from positions 1 through 4, aligning
desired number setting with the recessed arrow.
•
Position 1 allows the lowest amount of air flow.
•
Position 4 allows the highest amount of air flow.
W ork piece and W ork Area Set U p
1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Route the air hose along a safe route to reach
the work area without creating a tripping hazard
or exposing the air hose to possible damage.
The air hose must be long enough to reach
the work area with enough extra length to
allow free movement while working.
Page 10
For tech nical q uestions, please call 1 -8 8 8 -8 6 6 -5 7 9 7 .
4. Push and snap the required 1/2" drive
impact socket (not included) onto the Anvil.
CAU TION! Only use im pact rated accessories
w ith th is tool. Other accessories may
shatter, chip, or crack during operation.
3. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
4. There must not be hazardous objects
(such as utility lines or foreign objects) nearby
that will present a hazard while working.
Item 61718