CentralPneumatic 69228 Manual del usuario - Página 11

Navegue en línea o descargue pdf Manual del usuario para Destornillador de impacto CentralPneumatic 69228. CentralPneumatic 69228 16 páginas. 3/4" heavy duty air impact wrench

Imprimir página

General Operating instructions

1. If an automatic oiler is not used, add a few

drops of Pneumatic Tool Oil to the airline

connection before use. Add a few drops

more after each hour of continual use.

note: Turn off the air compressor and disconnect

the air hose when changing sockets.

2. Select the desired size 3/4" drive

impact socket (sold separately).

3. Push the socket onto the Anvil until it clicks into place.

4. Connect the air hose and turn on the air compressor.

5. Adjust the Air Regulator on the Impact Wrench

as needed for higher or lower pressure.

6. Press the Reverse Valve to set the direction:

• Reverse - counterclockwise rotation Push

Valve towards the back of the tool.

• Forward - clockwise rotation

Push Valve towards the front of the tool.

7. If tightening the nut, tighten by

hand as much as possible.

8. Position the socket on the Impact

Wrench over the nut.

9. Grip the Impact Wrench firmly with two

hands and gently squeeze the Trigger.

WaRninG! Do not hold socket or extension during

use to prevent serious injury from entanglement.

Item 69228

For technical questions, please call 1-800-444-3353.

10. If the tool requires more force to accomplish

the task, verify that the tool receives sufficient,

unobstructed airflow (CFM) and increase the

pressure (PSI) output of the regulator up to the

maximum air pressure rating of this tool.

cautiOn! tO pREVEnt injuRy FROm

tOOl OR accESSORy FailuRE:

Do not exceed the tool's

maximum air pressure rating.

If the tool still does not have sufficient force

at maximum pressure and sufficient airflow,

then a larger tool may be required.

11. When the nut is tightened or

loosened, release the Trigger.

12. To prevent accidents, turn off the tool, detach

the air supply, safely discharge any residual air

pressure in the tool, and release the throttle and/

or turn the switch to its off position after use.

Clean external surfaces of the tool with clean,

dry cloth, and apply a thin coat of tool oil.

Then store the tool indoors out of children's reach.

13. When tightening, if needed, check the

recommended torque specification for the nut

and tighten the nut further, to the proper setting,

using a torque wrench (sold separately).

Page 11